2000 Rover 45

Nearside Rear Trailing arm rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear passenger door cannot be opened from outside the vehicle handle broken (6.2.B.1c)

Nearside Stop lamp not working (1.2.1b)

Offside Front Seat belt anchorage prescribed area is excessively corroded floor (5.2.6)

Offside Rear Trailing arm rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Front Tyre worn close to the legal limit both (4.1.E.1)

Nearside Front Seat belt anchorage prescribed area is corroded but not considered excessive floor (5.2.6)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Inner Stop lamp not working (1.2.1b)

Nearside Rear passenger door catch deteriorated so the door cannot be readily opened or closed (6.2.B.2)

Offside Rear position lamp(s) not working (1.1.A.3b)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Centre exhaust section heavily corroded and deteriorated

Nearside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

screen washers poor

Nearside Headlamp aim too low (1.8)

Nearside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Headlamp aim too low (1.8)

Offside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

screen washers poor

Nearside rear brake recording little or no effort (3.7.B.5a)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

rear brake application uneven (3.7.B.2)

Front Brake pad(s) wearing thin (3.5.1g)

nearside rear brake binding

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

both front tyres worn to 3mm

rear number plate starting to discolour around edges

o/s + n/s abs rings split,at the front on cv joints.