2000 Honda Accord

Rear Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

Front Coil spring corroded (5.3.1 (b) (i))

Offside Suspension component mounting prescribed area is corroded but not considered excessive outersill (5.3.6 (a) (i))

Nearside Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Rear Inner Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security Sills (6.2.2 (d) (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Rear Inner Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security Sills (6.2.2 (d) (i))

Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt Both (2.5.C.1a)

Battery insecure (1.9.1)

Driver's airbag missing (5.4.1)

Exhaust catalytic converter missing where one was fitted as standard (7.1.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Headlamp aim too high both (1.8)

Horn not working (1.6.2a)

Nearside Rear Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Parking brake: efficiency below requirements (3.7.B.7)

Registration plate lamp not working both (1.1.C.1d)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Front Tyre worn close to the legal limit both (4.1.E.1)

Nearside Rear tyre is a retread

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside rear brake recording little or no effort (3.7.B.5a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brake pad(s) wearing thin (3.5.1g)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)