2000 Peugeot 106

ABS system checked, new sensor fitted.no faults found diag check ok

Brake pipe slightly corroded (3.6.B.2c)

Offside Headlamp deteriorated but light output not reduced (1.7.5a)

Rear Brake pad(s) wearing thin (3.5.1g)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

airbag light on

rear brake discs corroded

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Brake load sensing valve seized (3.6.E.3)

Driver's seat insecure (6.2.A.1)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front suspension has excessive play in a lower wishbone bearing (2.5.B.1a)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Brake pipe slightly corroded (3.6.B.2c)

Offside Headlamp deteriorated but light output not reduced (1.7.5a)

Rear Brake pad(s) wearing thin (3.5.1g)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

airbag light on

offside front ABS wire not fully secured

rear brake discs corroded

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Driver's seat insecure (6.2.A.1)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Nearside Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Steering rack gaiter missing (2.2.D.2d)

Parking brake: efficiency below requirements (3.7.B.7)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Outer Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Outer Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Offside Steering rack gaiter split (2.2.D.2d)

Nearside inner c/v boot split

Offside Steering rack gaiter deteriorated (2.2.D.2d)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Rear Registration plate lamp not working (1.1.5c)

Nearside Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Registration plate lamp not working (1.1.5c)

Offside Rear fog lamp not working (1.3.2b)

Offside Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Air bag light on

Nearside Rear Radius arm has slight play in a pin bearing (2.4.G.2)

Offside Rear Radius arm has slight play in a pin bearing (2.4.G.2)

Brakes imbalanced across an axle (3.7.B.5b)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Radius arm has excessive play in a pin/bearing (2.4.G.2)

Offside Rear Radius arm has excessive play in a pin/bearing (2.4.G.2)

Offside Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Offside Registration plate lamp not working (1.1.5c)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone 'A' (8.3.1b)

Offside Rear brake disc slightly pitted (3.5.1h)

Spare tyre defective

offside front fog light not working

screenwash bottle insecure infront of offside front wheel

Offside Rear brake disc slightly pitted (3.5.1h)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

both rear axle bearings worn

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Anti-roll bar linkage insecure (2.4.G.1)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Offside Stop lamp not working (1.2.1b)

Rear Brake load sensing valve linkage seized (3.6.E.3)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Rear Exhaust mounting missing (7.1.1b)

Driver's door does not latch securely closed (6.2.B.1a) DANGEROUS

Offside Rear brake disc slightly pitted (3.5.1h)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

both rear axle bearings worn

Fuel system component insecure (7.2.1)

Offside Side repeater incorrect colour (1.4.A.2f)