2000 Peugeot 106

Rear Passenger seat(s) missing at time of test ()

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Rear Passenger seat(s) missing at time of test ()

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Brake pedal anti-slip provision missing (3.3.A.1b)

Driver's seat cannot be secured in the upright position. (6.2.A.2)

Front Anti-roll bar insecure (2.4.G.1)

Front Tyre fouling a part of the vehicle (4.1.D.2)

Hand operated control valve unit insecure (3.2.2a)

Parking brake: efficiency below requirements (3.7.B.7)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Track rod end ball joint has slight play (2.2.B.1f)

Offside Front Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Headlamp aim too low (1.8)

Nearside Rear Radius arm has excessive play in a pin/bearing (2.4.G.2)

Nearside Rear passenger seat cannot be secured in the upright position. (6.2.3)

Nearside Registration plate lamp not working (1.1.5c)

Offside Headlamp aim too low (1.8)

Offside Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

brake fluid cylinder top missing

off side driving light inop

Advise Nearside Front Wing Undershield Missing

Nearside Front Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Outer Rear brake disc slightly pitted (3.5.1h)

Brake load sensing valve linkage defective and function impaired (3.6.E.3)

Nearside Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside rear brake recording little or no effort (3.7.B.5a)

Offside rear brake recording little or no effort (3.7.B.5a)

Service brake: efficiency below requirements (3.7.B.7)

Advise Nearside Front Wing Undershield Missing

Nearside Front Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Outer Rear brake disc slightly pitted (3.5.1h)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Emissions not tested (7.0)

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Rear Mechanical brake component has restricted free movement (3.5.1k)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp aim too high (1.8)

Oil leak

Front Steering component mounting prescribed area is distorted but not considered excessive (2.2.C.1h)

Front Subframe mounting prescribed area is distorted but not considered excessive (2.4.A.3)

Front Suspension component mounting prescribed area is distorted but not considered excessive (2.4.A.3)

Front brake disc slightly scored (3.5.1h)

Rear Suspension component mounting prescribed area is distorted but not considered excessive (2.4.A.3)

Rear brake disc slightly scored (3.5.1h)

Vehicle structure has slight damage (6.1.A.1)

Nearside Headlamp aim too low when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Seat belt anchorage prescribed area is severely distorted (5.2.6)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp aim too high when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Rear Suspension component mounting prescribed area is severely distorted (2.4.A.3)

Offside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b) DANGEROUS

Front brake disc slightly scored (3.5.1h)

Rear brake disc slightly scored (3.5.1h)

Seat belt anchorage prescribed area is distorted but not considered excessive (5.2.6)

Suspension component mounting prescribed area is distorted but not considered excessive (2.4.A.3)