2000 Kawasaki Zephyr 550

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Front wheel bearings are excessively rough (2.3.5b)

Headlamp aim beam image kick up to the offside (1.6)

Rear wheel bearings have excessive free play (2.4.A.2c)

Front Front wheel bearings have slight free play (2.3.5b)

Headlamp masks/converters fitted

Front position lamp does not illuminate immediately when switched on (1.1.3a)

Headlamp aim beam image kick up to the offside (1.6)

Headlamp aim too low (1.6)

Offside Rear shock absorber seal failed and leaking oil (2.4.A.1c)

Nearside Rear shock absorber has a light misting (2.4.A.1c)

Chain guard missing

Rear Tyre worn close to the legal limit (4.1.3(ii))

speedo not working

Front Brake lever is so short and the brake cannot be readily applied (3.1.3c)

Front Front position lamp does not illuminate immediately when switched on (1.1.3a)

Front Headlamp aim beam image kick up to the offside (1.6)

Front Riders seat insecure (6.2.1a)

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Front Throttle operating incorrectly (6.2.1f)

Rear Drive chain sprocket carrier worn to excess (6.2.1e)

Rear Tyre has a tear caused by separation or partial failure of its structure (4.1.2a(ii))

Chain guard missing

Rear Drive chain slightly loose (6.2.1d)

n/s side cover missing ,seat torn

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear Brake pedal has inadequate reserve travel (3.1.3b)

Roller brake test The less effective brake control does not achieve an efficiency of 25%. (3.3.A2b)

Drive chain worn to excess (6.2.1e) DANGEROUS

Wheel alignment slightly misaligned. (2.5.1)

Front Exhaust excessively deteriorated (7.1.1a)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Throttle operating incorrectly (6.2.1f)