2000 Yamaha FZS600

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Headlamp light intensity reduced (4.1.4 (a))

Front Motorcycle structure is fractured but structural rigidity is not significantly reduced (6.1.1 (a) (i))

Front Tyre worn close to the legal limit (5.2.3 (e))

Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Footrest rubber damaged

Offside Rear Chain adjuster not fitted correctly

Offside oil leak

Nearside Front Footrest rubber worn

Rear Tyre worn close to the legal limit (5.2.3 (e))

Floor brake test The less effective brake control does not achieve an efficiency of 25% (1.2.2 (a) (i))

Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Fuel system component leaking (6.1.3 (b) (i))

Front Tyre worn close to the legal limit (5.2.3 (e))

Front Brake pad(s) less than 1.0 mm thick (1.1.13 (a)) DANGEROUS

Drive chain slightly loose (6.1.7 (c) (i))

Front Brake pad(s) close to minimum limit (1.1.13 (a))

Front Tyre worn close to the legal limit (5.2.3 (e))

Drive chain slightly loose (6.1.7 (c) (i))

Front Brake pad(s) close to minimum limit (1.1.13 (a))

Front Tyre worn close to the legal limit (5.2.3 (e))

Rear Brake cylinder operating mechanism has excessive travel (1.1.16 (e) (i))

Rear Brake pad(s) close to minimum limit (1.1.13 (a))

Rear Wheel bearing has slight play (5.1.3 (a) (i))

Front position lamp does not illuminate immediately when switched on (1.1.3a)

Front Brake disc(s) slightly scored (3.2.A1l)

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Rear Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Drive chain slightly loose (6.2.1d)

Front Brake disc(s) slightly scored (3.2.A1l)

Front Brake fluid reservoir fluid level low (3.2.B1d)

Rear wheel has a loose wheel nut(s) (4.2.3a)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Drive chain slightly loose (6.2.1d)

Steering movement slightly 'notchy' (2.2.1b)

front brake binding slightly

has cuts in front tyre

Brake lever cannot be applied smoothly (3.1.3d)

Front Roller brake test indicates a severely grabbing brake (3.3.A1b)

Front wheel bearings have excessive free play (2.3.5b)

Rear Roller brake test indicates brake effort rise disproportional to brake lever or pedal effort (3.3.A1c)

Steering movement slightly 'notchy' (2.2.1b)

front brake binding slightly

has cuts in front tyre

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Front Headlamp aim too high (1.6)