2000 Ford Mondeo

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Rear Anti-roll bar linkage synthetic bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Anti-roll bar linkage synthetic bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

rear parking (secondary) brakes imbalanced (3.7.B.6b)

Offside Inner Rear Braking system leaking (3.6.A.1) DANGEROUS

Brake pipe slightly corroded (3.6.B.2c)

Nearside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

fuel filter heavily corroded

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside rear brake binding (3.7.B.1)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Brake hose has insufficient room to move, resulting in fouling on any part (3.6.B.4a)

Offside Front Tie bar/rod attachment bracket/mounting nut missing (2.4.G.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside rear brake recording little or no effort (3.7.B.5a)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Track rod end ball joint has excessive play (2.2.B.1f)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Parking brake is not capable of being maintained in operation by direct mechanical action only (3.1.2)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Offside Front Anti-roll bar locating pin locking device missing (2.4.G.3b)

Offside Front Track rod end ball joint has excessive play (2.2.B.1f)

Rear Anti-roll bar locating pin locking device missing (2.4.G.3b)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Brake pipe excessively corroded (3.6.B.2c)

Offside Front Headlamp aim too low when the centre of the headlamp is below 850mm from the ground (1.6.B2)