2000 Rover Mini

Rear Outer Suspension arm pin or bush worn but not resulting in excessive movement radius arm bearing play (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Direction indicator not working all (4.4.1 (a) (ii))

Emissions not tested oil leak (8.2.1.2 (d))

Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting panel under and around headlights (6.2.2 (d) (i))

Hazard warning lamps inoperative (4.4.1 (e))

Nearside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner and outer arch section / closing panel (6.2.2 (d) (i))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill under door (6.1.1 (c) (i))

Offside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting floor (6.2.2 (d) (i))

Offside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner and outer arch section / closing panel (6.2.2 (d) (i))

Offside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Rear Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting arch section (6.2.2 (d) (i))

Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting floor (6.2.2 (d) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced panel under bumper (6.1.1 (c) (i))

Rear Service brake efficiency below requirements (1.2.2 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Suspension arm ball joint has slight play all (5.3.4 (a) (i))

Front Suspension arm has slight play in a ball joint (2.4.G.2)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Horn not working (1.6.2a)

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Nearside Outer Subframe mounting prescribed area is excessively corroded sill (2.4.A.3)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Offside Outer Subframe mounting prescribed area is excessively corroded sill (2.4.A.3)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Registration plate lamp not working (1.1.C.1d)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Body has slight corrosion (6.1.B.2)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Brake back plate(s) securing device loose (3.5.1j)

Nearside Rear brake drum contaminated by brake fluid (3.5.1h)

Body has slight corrosion (6.1.B.2)

Exhaust has a minor leak of exhaust gases (7.1.2)

Oil leak

all front balljoint gaiters have no securing ring on the balljoint covers

Front registration plate insecure (6.3.1b)

Inner Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Upper Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Outer Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear rear brake binding (3.7.B.1)

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

rear brake application uneven (3.7.B.2)

Oil leak

all front balljoint gaiters have no securing ring on the balljoint covers

Nearside Front Lower Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Front Sub-frame attachment rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Sub-frame attachment rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Lower Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Rear Brake pivot has restricted free movement (3.5.1k)

Offside Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone 'A' (8.3.1b)

Parking brake: efficiency below requirements (3.7.B.7)

offside sill front end excessively corroded but not within prescribed area

Nearside Front Ball joint has slight play (2.2.B.1f)

Offside Front Ball joint has slight play (2.2.B.1f)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Front Ball joint has slight play (2.2.B.1f)

Offside Front Ball joint has slight play (2.2.B.1f)

Offside Rear Front wheel bearing has slight play (2.5.A.3c)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

offside front tyre inner secondary tread badly worn