2000 Rover 25

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Nearside Headlamp aim too high (4.1.2 (a))

Nearside Headlamp insecure (4.1.1 (c))

Nearside Rear Upper Coil spring mounting corroded and seriously weakened (5.3.1 (b) (i))

Offside Front Lower Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Offside Front Sub-frame corroded and seriously weakened (5.3.3 (b) (i))

Offside Headlamp aim too high (4.1.2 (a))

Offside Headlamp insecure (4.1.1 (c))

Offside Rear Lower Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Upper Coil spring mounting corroded and seriously weakened (5.3.1 (b) (i))

Front Brake pipe corroded, covered in grease or other material N/S and O/S (1.1.11 (c))

Rear Brake pipe corroded, covered in grease or other material N/S and O/S (1.1.11 (c))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear service brake effort low for this car

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Exhaust mounting defective heat shield loose (6.1.2 (a))

Rear Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

Vehicle structure is corroded but structural rigidity is not significantly reduced drivers side sill (6.1.1 (c) (i))

Front Brakes imbalanced across an axle (1.2.1 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge 1.6mm (5.2.3 (e))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Exhaust mounting defective heat shield loose (6.1.2 (a))

Rear Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

Vehicle structure is corroded but structural rigidity is not significantly reduced drivers side sill (6.1.1 (c) (i))

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Offside Front Track rod end ball joint has excessive play (2.2.B.1f)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Centre Upper Stop lamp has light sources not illuminating, but not more than 50% (1.2.1b)

Corrosion on sills should be kept under observation.

O/S/F tyre wear should be kept under observation.

Play in steering rack inner joint(s)

N/S/F wheel speed sensor ring burst.

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

N/S/F wheel speed sensor ring burst.

Offside Body has slight corrosion (6.1.B.2)

Nearside Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Front Exhaust system not adequately supported (7.1.1)

N/S/F driveshaft speed sensor reluctor ring burst.

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Tyre worn close to the legal limit (4.1.E.1)

Slight wear in o/s side tube of steering rack.

generak underbody surface corrosion requires treating

n/s front driveshaft reluctor ring split ( non abs)

Nearside Front Road wheel badly damaged (4.2.A.1a)

Rear Stop lamp not working (1.2.1b)