2000 Mazda 626

Anti-roll bar linkage corroded but not seriously weakened (2.4.G.1)

Brake pipe slightly corroded (3.6.B.2c)

Exhaust has part of the system slightly deteriorated (7.1.1a)

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Suspension weakened but no possibility of the body or a component fouling a road wheel (2.4.A.1b)

Vehicle structure has slight corrosion (6.1.B.2)

coil spring corroded (2.4.C.1b)

front discs worn on inner side

fuel cap not standard,,

Front front brake juddering slightly (3.7.A.2b)

Parking brake lever ratchet mechanism is slightly worn (3.1.5)

wipers starting to smear

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Front position lamp(s) not working (1.1.A.3b)

Headlamp aim not tested (1.8.A.1c)

Headlamp not working on dipped beam (1.7.5a)

Nearside Body has a sharp edge caused by damage (6.1.C.1)

Nearside Rear Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Offside Front Body has a sharp edge caused by damage (6.1.C.1)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Front Headlamp aim too high when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Headlamp aim too high when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Offside Rear Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front Brake pad(s) wearing thin (3.5.1g)

o/s front side light dim

o/s rear door damaged and dose not open