2012 Audi A1

Offside Rear Drive shaft joint constant velocity boot severely deteriorated rear end leaking grease (6.1.7 (g) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Headlamp aim too high (4.1.2 (a))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Exhaust corroded

Tyre worn close to legal limit/worn on edge Both rear tyres (5.2.3 (e))

Brake disc significantly and obviously worn Rear discs (1.1.14 (a) (i))

Brake pad(s) less than 1.5 mm thick Rear pads (1.1.13 (a) (ii)) DANGEROUS

Exhaust corroded

Tyre worn close to legal limit/worn on edge Both rear tyres (5.2.3 (e))

Front Windscreen wiper blade defective (3.4 (b) (i))

Rear Service brake binding but not excessively both side (1.2.1 (f))

Offside Front Upper Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Upper Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Brake disc worn, but not excessively Discs with lip. (1.1.14 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge Both edges bald. (5.2.3 (e))

Rear exhaust box's skin partly rotten, not blowing.

Offside Rear Brake pad(s) less than 1.5 mm thick CLOSE TO METAL !! (1.1.13 (a) (ii)) DANGEROUS

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure CRACKED TO CORD !! (5.2.3 (d) (ii)) DANGEROUS

Front Brake disc worn, but not excessively Discs with lip. (1.1.14 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge Both edges bald. (5.2.3 (e))

Nearside Rear Tyre has a cut but not deep enough to reach the ply or cords Outer wall. (5.2.3 (d) (i))

Rear exhaust box's skin partly rotten, not blowing.

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)