2000 Toyota MR2

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Suspension component mounting prescribed area is corroded but not considered excessive all under body (5.3.6 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Front Registration plate missing (0.1 (a))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Suspension component mounting prescribed area is corroded but not considered excessive all under body (5.3.6 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Headlamp has a product on the light source so that the light output is severely reduced (4.1.4 (b))

Offside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Headlamp aim too high (4.1.2 (a))

Offside Front Headlamp aim too high (4.1.2 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Front Headlamp has a product on the lens so that the light output is severely reduced both (4.1.4 (b))

Nearside Front Service brake excessively binding (1.2.1 (f))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Suspension component mounting prescribed area is corroded but not considered excessive all under body (5.3.6 (a) (i))

Brake disc worn, but not excessively all (1.1.14 (a) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Shock absorber has a serious fluid leak (2.7.3)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front rear brake binding (3.7.B.1)

Offside Rear Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Rear rear parking brake recording little or no effort (3.7.B.6a)

rear brake application uneven (3.7.B.2)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front front brake binding (3.7.B.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Headlamp aim too high (1.8)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Shock absorber has a light misting of oil (2.7.3)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Front brake disc slightly pitted (3.5.1h)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Headlamp damaged but light output not reduced (1.7.5a)