2000 BMW 528

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Shock absorbers light misting of oil or has limited damping effect Both front (5.3.2 (b))

Sub-frame pin or bush worn but not resulting in excessive movement Both rear (5.3.4 (a) (i))

Suspension arm pin or bush worn but not resulting in excessive movement Both front (5.3.4 (a) (i))

Headlamp not working on dipped beam both front (1.7.5a)

Nearside Rear position lamp(s) not working (1.1.A.3b)

advise 4 wheel alignment

both front tyres wearing on edges. re-check in 2-3k

n/s/r tyre wearing on inner edge. re-check in 2-3k

o/s/r tyre bald on inner edge. less than 2k

Nearside Front Anti-roll bar linkage ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Direction indicator slightly discoloured (1.4.A.2f)

Torque/reaction arm has a slightly deteriorated rubber bush (2.4.G.2)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Direction indicator slightly discoloured (1.4.A.2f)

Offside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Headlamp aim too low (1.8)

Offside Rear Suspension arm has excessive play in a ball joint (2.4.G.2)

Direction indicator slightly discoloured (1.4.A.2f)

Offside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Front Headlamp deteriorated but light output not reduced (1.7.5a)

Offside Front Headlamp deteriorated but light output not reduced (1.7.5a)

Offside Front Headlamp not in a clean condition affecting beam image (1.2.4a)

Offside Outer Rear Stop lamp not working (1.2.1b)

Nearside Front Headlamp deteriorated but light output not reduced (1.7.5a)

Nearside Headlamp aim too high (1.8)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)