2000 Honda Integra

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Brake performance not tested Due To Brake Pipe Leak (1.2.1 (g))

Brake pipe excessively corroded Middle To Rear X4 Pipes (1.1.11 (c))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Headlamp not working on main beam (4.1.1 (a) (ii))

Registration plate lamp missing in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Brake pipe leaking on a hydraulic braking system Middle To Rear Pipe (1.1.11 (b) (ii)) DANGEROUS

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Exhaust catalytic converter missing where one was fitted as standard (8.2.1.1 (a))

Nearside Front Lower Suspension component insecurely attached ball joint split pin missing (5.3.3 (a) (i))

Nearside Front Tyre not fitted in accordance with side wall instructions (5.2.3 (i))

Nearside Headlamp aim too high (4.1.2 (a))

Offside Front Lower Suspension component insecurely attached ball joint split pin missing (5.3.3 (a) (i))

Offside Front Tyre not fitted in accordance with side wall instructions (5.2.3 (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim too low (1.8)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

front windows tinted

Brakes imbalanced across an axle (3.7.B.5b)

Service brake: efficiency below requirements (3.7.B.7)

front windows tinted

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Offside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Rear Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Rear Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Inner Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Inner Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Headlamp aim too low (1.8)

Offside Front Headlamp aim too high (1.8)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Headlamp aim too low (1.8)

Nearside front brake binding (3.7.B.1)

Offside Rear wheel bearing rough when rotated (2.6.1)

Nearside Headlamp aim too high (1.8)

Headlamp aim too low (1.8)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)