2000 Nissan Micra

Nearside Brake pipe slightly corroded front to rear (3.6.B.2c)

Offside Brake pipe slightly corroded front to rear (3.6.B.2c)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Exhaust has a major leak of exhaust gases centre section (7.1.2)

Nearside Front Front suspension locking device ineffective driveshaft (2.5.A.4)

Nearside Front Front wheel bearing rough when rotated (2.5.A.2)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Front suspension locking device missing driveshaft (2.5.A.4)

Nearside Brake pipe slightly corroded front to rear (3.6.B.2c)

Offside Brake pipe slightly corroded front to rear (3.6.B.2c)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front Body has a sharp edge caused by damage (6.1.C.1)

Offside Front Front constant velocity joint is insecure locking device missing (2.5.C.1b)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Suspension component mounting prescribed area is excessively corroded rear axle (2.4.A.3)

Exhaust has a minor leak of exhaust gases rear joint (7.1.2)

Offside Headlamp aim too high (1.8)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside front wheel nuts fitted incorrectly

Offside front wheel nuts fitted incorrectly

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Outer Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside front wheel nuts fitted incorrectly

Offside front wheel nuts fitted incorrectly

Rear Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Front Vehicle structure has excessive corrosion which adversely affects braking or steering (6.1.A.1)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim too high (1.8)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Registration plate lamp not working (1.1.C.1d)

Nearside Front Body has slight corrosion (6.1.B.2)

Nearside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front constant velocity joint is slightly worn (2.5.C.1b)

Front Body has slight corrosion (6.1.B.2)

Brakes imbalanced across an axle (3.7.B.5b)

Centre Rear Exhaust has a major leak of exhaust gases (7.1.2)

Centre Rear Exhaust has part of the system excessively deteriorated (7.1.1a)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)