2000 Nissan Micra

Oil level low.

Rear Corrosion on under side of vehicle and corroded on both rear wheel arches behind bumper.

Electrical wiring insecure and connectors likely to become disconnected Battery terminal insecure. (4.11 (a) (ii))

Headlamp aim not tested (4.1.2 (b))

Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner sill corroded. (5.3.6 (a) (i))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill corroded. (5.3.6 (a) (i))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill corroded. (5.3.6 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill corroded. (5.3.6 (a) (i))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps Both lights not working. (4.7.1 (b) (ii))

Oil level low.

Rear Corrosion on under side of vehicle and corroded on both rear wheel arches behind bumper.

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

underside of vehicle has slight corrosion throughout

Offside Inner Seat belt anchorage prescribed area strength or continuity significantly reduced sill/ floor (7.1.1 (a) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

underside of vehicle has slight corrosion throughout

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength INNER SILL (5.3.6 (a) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Tyre worn close to the legal limit 3mm (4.1.E.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Outer Seat belt anchorage prescribed area is excessively corroded sill (5.2.6)

Nearside Rear Inner Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Nearside Rear Outer Suspension component mounting prescribed area is severely distorted sill (2.4.A.3)

Offside Rear Inner Suspension component mounting prescribed area is severely distorted sill (2.4.A.3)

Offside Rear Outer Suspension component mounting prescribed area is severely distorted sill (2.4.A.3)

Nearside Front Tyre worn close to the legal limit 3mm (4.1.E.1)

Nearside Rear Suspension component mounting prescribed area is excessively corroded INNER SILL (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded OUTTER SILL (2.4.A.3)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front front brake binding (3.7.B.1)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Nearside Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Offside Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Offside Rear rear brake recording little or no effort (3.7.B.5a)

Offside front brake binding (3.7.B.1)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Outer Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Registration plate lamp not working (1.1.C.1d)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Headlamp aim too high (1.8)

Nearside Stop lamp not working (1.2.1b)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Headlamp aim too high (1.8)

Offside Stop lamp not working (1.2.1b)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear registration plate faded (6.3.1d)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Stop lamp not working (1.2.1b)

Offside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Stop lamp not working (1.2.1b)

Rear registration plate deteriorated (6.3.1d)

sliaght play in rack arms

Offside Headlamp aim too low (1.8)

both rear tyres heavily cracked

nearside front tyre on 3mm

nearside rear tyre has slice on inner side wall but unable to see plys

offside front tyre on 2mm

rear number plate detiorating

both rear tyres heavily cracked

nearside front tyre on 3mm

nearside rear tyre has slice on inner side wall but unable to see plys

offside front tyre on 2mm

rear number plate detiorating

both rear tyres cracking

rear numberplate starting to fade

Nearside rear brake recording little or no effort (3.7.B.5a)

Offside Stop lamp not working (1.2.1b)

both rear tyres cracking

rear numberplate starting to fade

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)