2000 Mercedes-benz Vito

Nearside Front Body or chassis has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Inner Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front coil spring broken (2.4.C.1a)

Offside Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Parking brake: efficiency below requirements (3.7.B.7)

Vehicle structure excessively corroded within 30cm of towbar mounting (6.6.6)

rear parking brake recording little or no effort (3.7.B.6a)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Play in steering rack inner joint(s)

n/s/f inner driveshaft gaiter split

n/s/r wheel arch corroded

slam panel corroded

Brake pedal anti-slip provision missing (3.3.A.1b)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim not tested (1.8.A.1c)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Parking brake: efficiency below requirements (3.7.B.7)

Vehicle structure excessively corroded within 30cm of towbar mounting (6.6.6)

front brakes release unevenly (3.7.B.4)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Play in steering rack inner joint(s)

Nearside Front Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Inner Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Anti-roll bar linkage fractured (2.4.G.1)

Offside Inner Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Parking brake lever has no reserve travel (3.1.6b)

Rear Brake load sensing valve linkage seized (3.6.E.3)

Offside Rear Parking brake recording little or no effort (3.7.D.3a)

Parking brake: efficiency below requirements (3.7.B.7)

Brakes imbalanced across an axle (3.7.B.5b)

Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Front Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Outer Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Brake hose has insufficient room to move, resulting in fouling on any part (3.6.B.4a)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Brake hose has insufficient room to move, resulting in fouling on any part (3.6.B.4a)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Parking brake: efficiency below requirements (3.7.B.7)

Offside Outer Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear coil spring incomplete (2.4.C.1a)

Offside Rear coil spring incomplete (2.4.C.1a)

Offside Track rod end ball joint has excessive play (2.2.B.1f)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

Front Exhaust has part of the system slightly deteriorated (7.1.1a)

Offside Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Brake pedal anti-slip provision worn smooth (3.3.A.1b)

Nearside Front suspension has a suspension lower ball joint securing nut not locked (2.5.B.1a)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Brake load sensing valve linkage seized (3.6.E.3)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Exhaust emits an excessive level of metered smoke for a turbo charged engine (7.4.B.3b)

Nearside Front Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Exhaust has a major leak of exhaust gases (7.1.2)