2000 Honda Accord

Emissions unable to be completed (8.2.1.2 (d))

Offside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Inner wheel arch and sill end (6.2.2 (d) (i))

Rear Brake lining(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Oil leak, but not excessive (8.4.1 (a) (i))

Outer sills covered

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Brake hydraulic reservoir fluid level below minimum level (1.1.10 (d) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Rear Lower Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Nearside Rear Lower Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Lower Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced sill corroded inner and outer (6.1.1 (c) (i))

Offside Rear Nail in tyre nail and screw ()

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced sill corroded inner and outer (6.1.1 (c) (i))

sill covers fitted

Nearside Rear Outer Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security sill (6.2.2 (d) (i))

Nearside Headlamp aim too low (1.8)

Rear Brake Pads Aprox 50% worn.