2000 Subaru Impreza

Nearside Headlamp aim too low (1.8)

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings at jacking point marked in yellow chalk (6.1.B.2)

Offside Rear Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Nearside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Nearside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Offside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Nearside Rear Suspension component mounting prescribed area is inadequately repaired (2.4.A.3)

Nearside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Offside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Rear Trailing arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Trailing arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.C.1b)

Rear Brake pad(s) wearing thin (3.5.1g)

advise brake pedal anti-slip has some wear

advise no cover on nearside reg plat lamp

Brake pedal pad deteriorated, clutch pedal pad missing

Corrosion to brake servo casing

General corrosion to fuel filler tubes

General corrosion to subframes and suspension components

Plastic sill covers preventing full examination

Rear exhaust corroded and deteriorated with slight pin hole leak

Slight knock in front suspension

Some corrosion to rear metal brake pipes around union junction

Some grinding and grab from parking brake

Towbar partially obscuring rear number plate

Various small chips on screen

Bonnet cannot be secured in the closed position (8.4.1)

Nearside Outer Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear Suspension component mounting prescribed area is severely distorted (2.4.A.3)

Offside Outer Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Brake pedal pad deteriorated, clutch pedal pad missing

Corrosion to brake servo casing

General corrosion to fuel filler tubes

General corrosion to subframes and suspension components

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Plastic sill covers preventing full examination

Rea exhaust corroded and deteriorated, slight pin hole leak

Slight knock in front suspension

Some corrosion to rear metal brake pipes around union junction

Some grinding and grab from parking brake

Towbar partially obscuring rear number plate

Various small chips on screen

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Anti-roll bar linkage has slight play in a pin bearing (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Parking brake lever has little reserve travel (3.1.6b)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Headlamp aim too low (1.8)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Anti-roll bar linkage has slight play in a pin bearing (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Parking brake lever has little reserve travel (3.1.6b)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Rear Tie bar/rod has slight play in a pin/bush (2.4.G.2)

Offside Rear Tie bar/rod has slight play in a pin/bush (2.4.G.2)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Nearside Stop lamp not working (1.2.1b)

Nearside Rear Tie bar/rod has slight play in a pin/bush (2.4.G.2)

Offside Rear Tie bar/rod has slight play in a pin/bush (2.4.G.2)

Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Nearside Front Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Tyre worn close to the legal limit (4.1.E.1)

battery check required

some test items hidden by covers

Nearside Registration plate lamp insecure (1.1.C.1c)

Nearside Registration plate lamp not working (1.1.C.1d)

Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Nearside Front Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Tyre worn close to the legal limit (4.1.E.1)

battery check required

some test items hidden by covers

Plastic sill covers preventing full examination

Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)

Nearside Registration plate lamp not working (1.1.5c)

Offside Rear brake disc excessively pitted (3.5.1h)

Offside Registration plate lamp not working (1.1.5c)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)