2000 Toyota Yaris

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner and outer sills (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Fuel Pipe/s corroded ()

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Headlamp aim not tested (4.1.2 (b))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner and outer sills (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Fuel Pipe/s corroded ()

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

engine light on

o/s/ outer sill rusty

Brake load sensing valve linkage defective and function impaired bracket broken (3.6.E.3)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Rear coil spring broken (2.4.C.1a)

Offside Stop lamp not working (1.2.1b)

engine light on

o/s/ outer sill rusty

engine light on

n/s outer sill getting rusty

Brake valve insecurely mounted bracket to axle broken (3.6.A.2a)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust has a major leak of exhaust gases tail box (7.1.2)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Rear Subframe mounting prescribed area is excessively corroded closing panel (2.4.A.3)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

engine light on

n/s outer sill getting rusty

front discs rusty

fuel tank pipes rusty

Brake valve damaged broken off (3.6.A.2c)

Exhaust system not adequately supported front pipe (7.1.1)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

front discs rusty

front tyres worn on inner and outer edge

fuel tank pipes rusty

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Parking brake lever has little reserve travel (3.1.6b)

both front tyres getting low

front exhaust mount rusty

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Rear Coil spring not correctly located (2.4.C.2) DANGEROUS

Nearside Rear coil spring broken (2.4.C.1a) DANGEROUS

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Parking brake lever has little reserve travel (3.1.6b)

both front tyres getting low

front exhaust mount rusty

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Exhaust has a minor leak of exhaust gases (7.1.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

fan belt split

n/s/r tyre low bald on outer edge going out of shape and split

o/s/r tyre going out of shape starting to split wearing on outer edge

Nearside Headlamp has a product on the light source but not seriously reducing light output (1.7.5a)

Offside Headlamp has a product on the light source but not seriously reducing light output (1.7.5a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

both rear tyres going out of shape and starting to split

n/s/f tyre bald on inner and outer edges

o/s/f tyre bald on inner edge

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Outer Front Lower Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Outer Front Lower Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

water pump very noisey

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Direction indicators slightly discoloured (1.4.A.2f)

anti-roll bar rubbers split and worn

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp aim too high (1.8)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Headlamp aim too high (1.8)

rear brake application uneven (3.7.B.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Direction indicators slightly discoloured (1.4.A.2f)

anti-roll bar rubbers split and worn

Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

N/S/R starting to perrish around sidewall

Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)