2000 Ford Mondeo

Nearside Front Direction indicator incorrect colour (1.4.A.2f)

Nearside Rear Anti-roll bar linkage fractured (2.4.G.1)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Brake hose has insufficient room to move, resulting in fouling on any part (3.6.B.4a)

Offside Front Direction indicator incorrect colour (1.4.A.2f)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Registration plate lamp not working (1.1.C.1d)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Nearside Front Suspension arm has slight play in a pin/bush (2.4.G.2)

Nearside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

rear exhaust clamps corroded and weak

o/s rear tyre has slight cuts in outer tyre wall,no cords showing.

Offside Rear Anti-roll bar linkage fractured (2.4.G.1)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

o/s rear tyre has slight cuts in outer tyre wall,no cords showing.

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front coil spring fractured (2.4.C.1a)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Brake pad(s) wearing thin (3.5.1g)

tyre pressures were low

front tyres are wearing on edges-tyre pressures were only 25 psi

Nearside Registration plate lamp not working (1.1.5c)

front tyres are wearing on edges-tyre pressures were only 25 psi