2000 Jaguar Xkr

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement Slight movement in upper & lower inner bushes (5.3.4 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive Both chassis legs (5.3.6 (a) (i))

Sub-frame corroded but not seriously weakened Front & rear (5.3.3 (b) (i))

Nearside Brake pipe excessively corroded Front to rear (1.1.11 (c))

Offside Brake pipe excessively corroded Front to rear (1.1.11 (c))

Offside Front Lower Suspension arm pin or bush excessively worn Inner most bushes (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Split adjacent to previous repair (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive Both chassis legs (5.3.6 (a) (i))

Sub-frame corroded but not seriously weakened Front & rear (5.3.3 (b) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Brake pipe corroded, covered in grease or other material to rear (1.1.11 (c))

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Front Brake pipe corroded, covered in grease or other material to rear. (1.1.11 (c))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Underside of vehicle corroded.

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Front Lower Suspension arm pin or bush excessively worn inner (5.3.4 (a) (i))

Nearside Rear Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Lower Shock absorbers has a slightly worn bush (5.3.2 (c))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front Lower chassis brace badly corroded

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Lower Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Brake pipe corroded, covered in grease or other material front to rear pipe (1.1.11 (c))

Nearside Front cross brace corroded

Nearside Rear Tyre worn close to legal limit/worn on edge worn on edges (5.2.3 (e))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Supplementary restraint system warning lamp indicates a fault airbag light on (7.1.6 (a))

Nearside Front Brake pipe corroded, covered in grease or other material front to rear pipe (1.1.11 (c))

Nearside Front cross brace corroded

Nearside Rear Tyre worn close to legal limit/worn on edge worn on edges (5.2.3 (e))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength previous weld repair patch cracked and corroded by subframe mounting point (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength previous weld repair patch cracked and corroded by subframe mounting point (5.3.6 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material front to rear pipe (1.1.11 (c))

Nearside Front cross (X) brace corroded

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced floor by bolt mounting holed and corroded (7.1.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis kick up by axle (5.3.6 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced floor by bolt mounting holed and corroded (7.1.1 (a) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Offside Headlamp aim too low (4.1.2 (a))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive chassis (2.4.A.3)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive chassis (2.4.A.3)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front rim trim damaged

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Nearside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Nearside Front Lower Suspension arm has slight play in a pin/bush (2.4.G.2)

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Front Lower Suspension arm has slight play in a pin/bush (2.4.G.2)

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

hole and corrosion in drivers floor, outside all prescribed areas

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Nearside Front Lower Suspension arm has slight play in a pin/bush (2.4.G.2)

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Front Lower Suspension arm has slight play in a pin/bush (2.4.G.2)

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

hole and corrosion in drivers floor, outside all prescribed areas

Nearside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Nearside Front Lower Suspension arm has slight play in a pin/bush (2.4.G.2)

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Front Lower Suspension arm has slight play in a pin/bush (2.4.G.2)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

small hole and corrosion in offside front floor, outside all prescribed areas

slight play in rear suspension

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

slight play in rear suspension

Nearside Rear Drive shaft uj which forms part of the suspension has slight play in a universal joint (2.4.G.4b)

Offside Rear Drive shaft uj which forms part of the suspension has slight play in a universal joint (2.4.G.4b)

both front tyres slightly wearing on inner edge

some movement on both rear hubs

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Offside Front Brake hose seriously damaged (found during steering lock to lock check) (2.2.D.2b)

Offside Front Brake hose twisted (found during steering lock to lock check) (2.2.D.2b)

both front tyres slightly wearing on inner edge

n/s front hose slightly twisted almost fouling suspension on lock

some movement on both rear hubs

Nearside Rear rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Rear fog lamp tell tale not working (1.3.1b)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

both front tyres worn almost to canvas on inner edges

front brake hoses fouling on anti-roll bar links