2000 Piaggio Vespa

Front Lower Suspension rod pin or bush excessively worn (5.3.4 (a) (i))

Front Shock absorber has negligible damping effect (5.3.2 (b))

Headlamp not working on dipped beam (4.1.1 (a) (ii))

Lower Motorcycle structure corroded to the extent that the rigidity of the assembly is significantly reduced foot boards (6.1.1 (c) (i))

Steering headbearing has excessive wear or free play (2.2.2 (f) (i))

Front Stop lamp remains on when the brakes are released (4.3.2 (a) (iii)) DANGEROUS

Rear Tyre tread depth is below minimum requirements of 1.0mm (5.2.3 (e)) DANGEROUS

engine drive system very noisey

Steering headbearing has slight free play (2.2.2 (f) (i))

under side of leg shields very rusty

Fuel cap ineffective Sealing ring missing. (6.1.3 (b) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Front position lamp does not illuminate immediately when switched on (1.1.3a)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Fuel cap sealing washer missing (7.2.2c)

Horn not working (1.7.3a)

Rear Brake lever has inadequate reserve travel (3.1.3b)

Roller brake test The less effective brake control does not achieve an efficiency of 25%. (3.3.A2b)

Stop lamp remains on when the brake is released (1.3.1e)

Front suspension has a slightly reduced damping effect (2.3.6c)

Rear Tyre worn close to the legal limit (4.1.3(ii))

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)