2000 Rover Mini

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Horn not working (7.7 (a))

Nearside Front Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Headlamp aim too high (4.1.2 (a))

Nearside Side repeater not working (4.4.1 (a) (ii))

Offside Front Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Headlamp aim too high (4.1.2 (a))

Rear Sub-frame corroded and seriously weakened (5.3.3 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Windscreen washer not working (3.5 (a))

Nearside Rear Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) DANGEROUS

Offside Rear Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) DANGEROUS

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Seat belt anchorage prescribed area is corroded but not considered excessive outer sill. (7.1.1 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Offside rear brake binding (3.7.B.1)

Service brake: efficiency below requirements (3.7.B.7)

Supplementary Restraint System warning lamp indicates a fault electrical fault, unable to test any electrics on vehicle (5.4.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

over heated on ramp during test

Parking brake: efficiency below requirements (3.7.B.7)

Exhaust catalytic converter missing where one was fitted as standard (7.1.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Front Brakes imbalanced across an axle 30% (3.7.B.5b)

Headlamp aim too high x2 (1.8)

Horn not working (1.6.2a)

Nearside Front Subframe mounting prescribed area is excessively corroded floor/arch/sill (2.4.A.3)

Nearside Rear Sub-frame corroded and seriously weakened (2.4.G.1)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords sidewall (4.1.D.1a)

Nearside rear brake recording little or no effort (3.7.B.5a)

Offside Front Subframe mounting prescribed area is excessively corroded floor/sill (2.4.A.3)

Registration plate lamp not working (1.1.C.1d)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Tyre worn close to the legal limit bald outer edge (4.1.E.1)

Offside rear brake fluctuating, but not excessively (3.7.B.3)

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. 20% (3.7.B.5b)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Nearside Rear Stop lamp not working (1.2.1b)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Front Sub-frame attachment rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Headlamp aim too high (1.8)

Nearside Rear Radius arm insecure (2.4.G.1)

Offside Headlamp aim too low (1.8)

Offside Rear Radius arm insecure (2.4.G.1)

Offside Rear Sub-frame corroded and seriously weakened (2.4.G.1)

Brake hydraulic reservoir fluid close to minimum level (3.6.G.1b)

Offside Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Outer sills have slight corrosion

Score marks on front windscreen

Front Exhaust has a major leak of exhaust gases (7.1.2)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Front passenger seat cannot be secured in the upright position. (6.2.4)

Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)

Nearside Rear position lamp(s) not in a clean condition and function impaired (1.1.4a)

Nearside Side repeater not working (1.4.A.2c)

Offside Rear fog lamp excessively deteriorated so that it is not visible from a reasonable distance (1.3.2d)

Offside Rear fog lamp not working (1.3.2b)

Brake hydraulic reservoir fluid close to minimum level (3.6.G.1b)

Offside Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Score marks on front windscreen

Front Exhaust has a major leak of exhaust gases (7.1.2)

Fuel cap/sealing device sealing washer missing (7.2.4c)

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Outer Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Radius arm has excessive play in a pin/bearing (2.4.G.2)

Nearside Side repeater not working (1.4.A.2c)

Offside Outer Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Radius arm has excessive play in a pin/bearing (2.4.G.2)

Offside Rear fog lamp excessively deteriorated so that it is not visible from a reasonable distance (1.3.2d)

Offside Rear fog lamp not working (1.3.2b)

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

Windscreen washer provides insufficient washer liquid (8.2.3)

Rear subframe corroding

Nearside Front Front wheel bearing has excessive play (2.5.A.3c)

Nearside Front Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Offside Front Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Parking brake: efficiency below requirements (3.7.B.7)

play in front ball joints

play in osf bearing

rear subframe corroded