2000 Honda Integra

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill and inner wheel arch (5.3.6 (a) (i))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill and inner wheel arch (5.3.6 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust catalytic converter missing where one was fitted as standard (8.2.1.1 (a))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Exhaust has a minor leak of exhaust gases front pipe to centre section flange (6.1.2 (a))

Exhaust noisy (8.1.1 (a))

Nearside Front Shock absorbers has a slightly worn bush bottom strut bush (5.3.2 (c))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Shock absorbers has a slightly worn bush bottom strut bush (5.3.2 (c))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement Trailing arm bush (5.3.4 (a) (i))

Offside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement Trailing arm bush (5.3.4 (a) (i))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Brake pipe slightly corroded (3.6.B.2c)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

rust in places

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front brake disc slightly pitted (3.5.1h)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Upper Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)