2000 Honda ST1100

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Brake excessively binding (1.2.1 (f))

Headlamp aim too high (4.1.2 (a))

Offside Front Shock absorber has a serious fluid leak (5.3.2 (b))

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Brake indicates slight fluctuation of brake effort (1.2.1 (e))

Nearside Front Shock absorber has a slightly worn bush (5.3.2 (c))

Offside Front Shock absorber has a slightly worn bush (5.3.2 (c))

Rear Brake indicates slight fluctuation of brake effort (1.2.1 (e))

Rear Brake pad(s) close to minimum limit (1.1.13 (a))

Rear Tyre worn close to the legal limit (5.2.3 (e))

Upper Shock absorber has a slightly worn bush (5.3.2 (c))

Front Brake linked system has a slightly worn master cylinder pivot. (3.2.B5)

Motorcycle structure slightly corroded rear swing arm (6.1.1a)

Front Brake linked system has a slightly worn master cylinder pivot. (3.2.B5)

Front position lamp does not illuminate immediately when switched on (1.1.3a)

Motorcycle structure slightly corroded rear swing arm (6.1.1a)

Rear Nail in tyre ()

Rear Roller brake test indicates slight fluctuation of brake effort (3.3.A1d)

Rear suspension slightly corroded (2.4.A.2d)

Front Brake fluid reservoir fluid level dangerously low (3.2.B1d)

Rear Nail in tyre ()

Rear Roller brake test indicates slight fluctuation of brake effort (3.3.A1d)

Rear suspension slightly corroded (2.4.A.2d)

Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Nearside Front shock absorber has light misting of stanchion (2.3.3)

Offside Front shock absorber has light misting of stanchion (2.3.3)

Rear Brake disc(s) has slight run out (3.2.A1m)

Rear shock absorber has inadequate damping effect. (2.4.A.3b)

Front shock absorber seal failed and leaking oil (2.3.3) DANGEROUS

Rear Brake disc(s) has slight run out (3.2.A1m)

Centre Front Lower Roller brake test indicates a slightly grabbing brake (3.3.A1b)

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear Roller brake test indicates excessive fluctuation of brake effort (3.3.A1d)

Rear Brake pad(s) close to minimum limit (3.2.A1f(i))

Front Floor brake test indicates a slightly juddering brake (3.3C2d.)