2000 Toyota Yaris

Nearside Anti-roll bar rubber bush deteriorated but not resulting in excessive movement upper @ lower (2.4.G.2)

Offside Anti-roll bar rubber bush deteriorated but not resulting in excessive movement upper @ lower (2.4.G.2)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Anti-roll bar rubber bush deteriorated but not resulting in excessive movement upper @ lower (2.4.G.2)

Offside Anti-roll bar rubber bush deteriorated but not resulting in excessive movement upper @ lower (2.4.G.2)

Front Headlamp has a product on the lens but not seriously reducing light output both (1.7.5a)

Front Headlamp has a product on the light source but not seriously reducing light output both (1.7.5a)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

antierollbar outer bushes worn but not allowing excessive movement

Offside Front Tyre worn close to the legal limit (4.1.E.1)

engine light on

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Windscreen washer provides insufficient washer liquid (8.2.3)

engine light on

both front antirollbar bushes cracked

both rear coil springs corroded

engine management light on

front brake discs pitted

both rear coil springs corroded

both front tyres worn on edges

front wipers split

O/S/R and N/S/R tyres slight pereshing

Nearside Front position lamp(s) not working (1.1.A.3b)

both front anit roll link bar bushes cracking

nearside rear tyre sidewall cracking

offside rear tyre sidewall cracking

rear wiper blade split

sump corroded

both front anit roll link bar bushes cracking

nearside rear tyre sidewall cracking

offside rear tyre sidewall cracking

rear wiper blade split

sump corroded

Nearside Front Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (4.1.E.2a)

Offside Front Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (4.1.E.2a)

nearside rear tyre side wall cracking

offside rear tyre side wall cracking

sump corroded