2000 Suzuki Swift

Nearside Front Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Headlamp aim too low (1.8)

Offside Inner Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear rear brake application uneven (3.7.B.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside rear brake recording little or no effort (3.7.B.5a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Offside Rear Rear wheel bearing has excessive play (2.6.2) DANGEROUS

Fuel pipe/s corroded

Nearside Front Brake pad(s) wearing thin (3.5.1g)

coolent level low

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Exhaust tailpipe not capable of allowing the emission probe to be inserted (7.3.D.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

all brake pipes covered in grease

offside inner cv boot holed

parking brake needs adjusted

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Front Headlamp insecure (1.7.3)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

all brake pipes covered in grease

offside inner cv boot holed

Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Macpherson strut corroded and seriously weakened (2.4.G.1)

Nearside Headlamp aim too low (1.8)

Nearside Rear Front wheel bearing rough when rotated (2.5.A.2)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear fog lamp missing (1.3.2a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Registration plate lamp not working (1.1.C.1d)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Direction indicators slightly discoloured (1.4.A.2f)

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

STRONG ADVISE engine oil light staying on

both rear coil springs corroded

drivers seat belt frayed

front offside inner c.v. boot burst

rear fuel pipes corroded

Nearside Front Headlamp not working on main beam (1.7.5a)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Outer Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Rear rear brake recording little or no effort (3.7.B.5a)

Rear rear parking brake recording little or no effort (3.7.B.6a)

Rear Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

corrosion on rear cross member

heavy corrosion on offside front strut

slight corrosion on rear brake pipes at valve area

Front position lamp(s) incorrect colour (1.1.A.3e)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

corrosion on rear cross member

heavy corrosion on offside front strut

slight corrosion on rear brake pipes at valve area

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Road wheel badly damaged (4.2.A.1a)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Headlamp aim too low (1.8)

Nearside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Offside Front coil spring fractured (2.4.C.1a)

Offside Registration plate lamp not illuminating the registration plate (1.1.C.1e)

Offside rear brake recording little or no effort (3.7.B.5a)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Front Front constant velocity joint gaiter split (2.5.C.1a)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Front brake disc slightly scored (3.5.1h)

Offside Front brake disc slightly scored (3.5.1h)