2000 Rover 25

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Nearside Side repeater slightly discoloured (1.4.A.2f)

Offside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

rear exhaust corroded

Offside Inner Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front Anti-roll bar linkage rubber bush bonding deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front Tyre has ply or cords exposed (4.1.D.1b)

Nearside Outer Front constant velocity joint is insecure (2.5.C.1b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Inner Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

boot door not latching

corrosion rear exhaust

1 bulb not working centre stop light ;

Nearside Front Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Offside Front Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

slight damp power steering rack ;

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Power steering component(s) has slight seepage from a component (2.3.3b)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

one high level stop lamp bulb not working

Nearside Stop lamp not working (1.2.1b)

Power steering component(s) has slight seepage from a component (2.3.3b)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

one high level stop lamp bulb not working

1 high-level stop lamp bulb not working

Nearside Stop lamp not working (1.2.1b)

Offside Registration plate lamp not working (1.1.5c)

Offside Stop lamp not working (1.2.1b)

1 high-level stop lamp bulb not working