2000 Subaru Legacy

Central Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Central Exhaust has a minor leak of exhaust gases (7.1.2)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

Vehicle structure has slight corrosion (6.1.A.1)

Rear Brake pad(s) wearing thin (3.5.1g)

Vehicle structure has slight corrosion (6.1.A.1)

Offside Headlamp deteriorated but light output not reduced (1.7.5a)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

underside covered in mud making inspection difficult

Offside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

heavy corrosion in front brake discs ========= slight wear in o/s/r anti roll bar link

Offside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Tyre has ply or cords exposed (4.1.D.1b) DANGEROUS

heavy corrosion in front brake discs ========= slight wear in o/s/r anti roll bar link

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Headlamp aim too low (1.8)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nail in offside front tyre

n/s/r tyre worn inner edge

Offside Headlamp aim too low (1.8)

Offside Headlamp not working on main beam (1.7.5a)

n/s/r tyre worn inner edge

Front front brake application uneven (3.7.B.2)

Nearside Front Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear front brake binding (3.7.B.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Registration plate lamp not working (1.1.5c)

Exhaust has part of the system slightly deteriorated (7.1.1a)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Oil leak

Rear brake disc slightly pitted (3.5.1h)