2000 Fiat Ducato

Rear sil rusty

Front Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Subframe mounting prescribed area is corroded but not considered excessive covered in seal (5.3.6 (a) (i))

Offside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

surface rust under body

Front Wheel bearing has slight play both (5.1.3 (a) (i))

surface rust

Front Wheel bearing has slight play both (5.1.3 (a) (i))

Horn not working (7.7 (a))

surface rust

Nearside Front Brake prescribed area is corroded but not considered excessive brake pipe bracket to body (1.1.21 (e) (i))

Nearside Front Outer cv boot has a slight leak of grease

Offside Front Inner cv boot has a slight leak of grease

Oil leak, but not excessive (8.4.1 (a) (i))

both front tyres slightly cracking

both front wheel bearings have slight play

exhaust hitting body of vehicle

slight corrosion to vehicle body

under-body heavily under-sealed

Slight play in both front wheel bearings

Under body heavily undersealed

Brake pedal not releasing correctly and functionality of brakes affected goes to the floor (1.1.2 (b) (ii))

Brake performance not tested due to brake fluid leaking (1.2.1 (g))

Headlamp levelling device inoperative (4.1.5 (a))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Front Headlamp light source and lamp not compatible (4.1.4 (c))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch (5.3.6 (a) (i))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill panel ( rear leaf spring mounting ) (5.3.6 (a) (i))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Headlamp light source and lamp not compatible (4.1.4 (c))

Offside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch + chassis leg (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill panel ( rear leaf spring mounting ) (5.3.6 (a) (i))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps both (4.7.1 (b) (ii))

Brake fluid not visible (1.1.10 (d) (iii)) DANGEROUS

Brake valve leaking such that brake functionality is affected load sensing valve (1.1.7 (d) (ii)) DANGEROUS

Brake fluid warning lamp illuminated (1.1.10 (f))

Front Wheel bearing has slight play both (5.1.3 (a) (i))

Horn not working properly (7.7 (a) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

slight play in steering wheel - slightly buckled

underbody heavily covered in under seal

corrosion to rear crossmember

front inner arches corroded plus outer sills

exhaust rubbers perrished

front inner wings slightly corroded

front strut tops slightly stiff

Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Horn not working (1.6.2a)

Windscreen washer provides insufficient washer liquid (8.2.3)

corrosion in outer pannels underside

Nearside Front Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

corrosion in outer pannels underside

cracks in off side rear tyre

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust has part of the system excessively deteriorated (7.1.1a)

Exhaust mounting missing (7.1.1b)

Horn not working (1.6.2a)

Offside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Windscreen washer provides insufficient washer liquid (8.2.3)

Centre Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Lower Ball joint has slight play (2.2.B.1f)

Brake pipe excessively corroded (3.6.B.2c)

Exhaust mounting missing (7.1.1b)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Front Upper Brake pipe excessively corroded (3.6.B.2c)

Registration plate lamp not working (1.1.5c)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Registration plate lamp not working (1.1.5c)

Offside Front Macpherson strut upper support bearing is stiff in operation (2.5.B.1b) DANGEROUS

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

BRAKE PEDAL RUBBER S/DET

Brake pipe slightly corroded (3.6.B.2c)

Exhaust has part of the system slightly deteriorated (7.1.1a)

Front Front wheel bearing has slight play (2.5.A.3c)

Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Nearside Front Direction indicator slightly discoloured (1.4.A.2f)

Nearside Front Macpherson strut is slightly stiff in the upper support bearing assembly (2.5.B.1b)

Rear wheel bearing has slight play (2.6.2)