2000 Toyota Land Cruiser

Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Rear Seat belt damaged (7.1.2 (b) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Stop lamp(s) all not working (4.3.1 (a) (iii)) DANGEROUS

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced rear half (6.1.1 (c) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Emissions not tested (8.2.2.2 (e))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Offside Rear Rear fog lamp does not emit a steady red light (4.5.4 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Suspension component mounting prescribed area is excessively corroded chassis/spring/arm mounts (2.4.A.3)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Rear Suspension component mounting prescribed area is excessively corroded chassis severel areas (2.4.A.3)

Rear Fuel system component leaking (7.2.3)

Rear Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Nearside Lower Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Lower Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Front Brake pad(s) wearing thin (3.5.1g)

Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Rear Rear fog lamp emits a light other than red (1.3.2e)

Front Brake pad(s) wearing thin (3.5.1g)

Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Front Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Anti-roll bar linkage insecure (2.4.G.1)

Offside Rear rear parking brake recording little or no effort (3.7.B.6a)

Registration plate lamp not working (1.1.C.1d)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Steering system has slight free play detected at steering wheel (2.2.A.1b)

steering rack mountings slight movement

Fuel pipe/s corroded