2000 Fiat Punto

Brake pedal not releasing correctly and functionality of brakes affected bonnet release handle interfeering (1.1.2 (b) (ii))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Fuel cap/sealing device missing (6.1.3 (b) (i))

Horn not working (7.7 (a) (ii))

Nearside Front Service brake excessively fluctuating (1.2.1 (e))

Offside Front Inner Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Oil leaking excessively from engine (8.4.1 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Horn not working (7.7 (a) (ii))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Front Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected (5.3.6 (a) (ii)) DANGEROUS

Oil leak, but not excessive (8.4.1 (a) (i))

Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement both front (2.4.G.2)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Oil leak ()

both front bump stops broken

coil spring corroded both rear (2.4.C.1b)

Nearside Front Seat belt anchorage prescribed area is excessively corroded floor (5.2.6)

Nearside Rear position lamp(s) adversely affected by the operation of another lamp bad earth (1.1.A.3f)

Offside Front Seat belt anchorage prescribed area is excessively corroded floor (5.2.6)

Offside Headlamp aim too low and too far to the right. (1.8)

Offside Rear Seat belt anchorage prescribed area is excessively corroded inner wheel arch (5.2.6)

Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement both front (2.4.G.2)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Oil leak ()

both front bump stops broken

coil spring corroded both rear (2.4.C.1b)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Inner Suspension component mounting prescribed area is excessively corroded floor (2.4.A.3)

Offside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Inner Seat belt anchorage prescribed area is excessively corroded floor (5.2.6)

Offside Rear Inner Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Oil leak ()

eml

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Oil leak ()

Horn not working (1.6.2a)

Nearside Front Suspension component mounting prescribed area is excessively corroded floor (2.4.A.3)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Oil leak ()

oil leak

Front Electronic power steering warning lamp indicates a failure in the system (2.3.8)

Nearside Front Inner Suspension component mounting prescribed area is excessively corroded floor (2.4.A.3)

Nearside Front position lamp(s) not working (1.1.A.3b)

Steering system excessively tight (2.2.D.1)

oil leak

Oil leak

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Headlamp aim too high (1.8)

Offside Headlamp aim too low (1.8)

Nearside Rear Rear position lamp(s) slightly affected by the operation of another lamp (1.1.A.3f)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

all tyres perished,rear suspension corroded

Offside Front Lower Seat belt anchorage prescribed area is deliberately modified which significantly reduces the original strength (5.2.6)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Rear position lamp(s) slightly affected by the operation of another lamp (1.1.A.3f)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

all tyres perished,rear suspension corroded

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

nearside front and offside front floor corroded