2000 Aprilia RS 50

Front Shock absorber has a light misting of oil (5.3.2 (b))

Drive chain excessively tight (6.1.7 (k) (i))

Front Brake pad(s) contaminated (1.1.13 (b))

Front Shock absorber has a serious fluid leak (5.3.2 (b))

Front Shock absorber has negligible damping effect (5.3.2 (b))

Headlamp aim too far to the left front mount bent (4.1.2 (a))

Offside Front Direction indicator not working (4.4.1 (a) (ii))

Pillion seat with a defective supporting structure held on with self tapping screws upwards (6.2.6 (a) (i))

Rear Shock absorber has negligible damping effect (5.3.2 (b))

Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Rear Brake master cylinder leaking (1.1.10 (b) (ii)) DANGEROUS

Rear Wheel bearing play so excessive that directional control is impaired (5.1.3 (a) (ii)) DANGEROUS

Indicator switch insecure (4.4.2 (a) (i))

bare wires

bolts broken off engine casing

engine components missing

speedo cable attachment cross threaded

throttle return cable insecure

wire connections twisted together

Nearside Front Front shock absorber has light misting of stanchion (2.3.3)

Rear Rear shock absorber has a slightly reduced damping effect (2.4.A.3b)

front brake binding slightly.

rear brake pedal has slight travel.

Front Tyre valve stem damaged which could cause sudden tyre deflation (4.1.2c)

Headlamp aim too low (1.6)

Rear Tyre valve stem damaged which could cause sudden tyre deflation (4.1.2c)

Front Tyre worn close to the legal limit (4.1.3(i))

Nearside Front Front shock absorber has light misting of stanchion (2.3.3)

Rear Rear shock absorber has a slightly reduced damping effect (2.4.A.3b)

front brake binding slightly.

Clutch lever shortened. (6.2.1g)

Front Brake disc(s) slightly worn (3.2.A1l)

Rear Brake disc(s) slightly worn (3.2.A1l)

Rear Brake pedal is bent but brake can still be readily applied (3.1.3c)

Front Brake disc(s) excessively worn (3.2.A1l)

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Front suspension has inadequate damping effect. (2.3.6c)

Front wheel bearings are excessively rough (2.3.5b)

Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Rear Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Rear Tyre tread not clearly visible (4.1.3(i))

Rear suspension bush has excessive free play (2.4.A2a(i))

Steering headbearing has excessive free play (2.2.2)

Drive chain worn to excess (6.2.1e) DANGEROUS

Rear Drive chain sprocket worn to excess (6.2.1e) DANGEROUS

Clutch lever shortened. (6.2.1g)

Rear Brake disc(s) slightly worn (3.2.A1l)

Rear Brake pedal is bent but brake can still be readily applied (3.1.3c)

Front Brake hose excessively chafed (3.2.B3a)

Rear Brake pad(s) (sintered type) less than 1.0mm thick (3.2A1f(ii))

Front Fairings so located that it is likely to impede the steering (2.1.2e)

Front Headlamp aim headlamp deteriorated and function impaired (1.2.3a)

Rear Footrest missing (6.2.1a)

An item not tested (Manual)

Nearside Indicator switch insecure (1.5.4)

Rear wheel bearings have excessive free play (2.4.A.2c)

Rear Drive chain slightly loose (6.2.1d)