2000 Mazda Bongo

Offside Front Upper Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength out rigger (5.3.6 (a) (i))

Nearside Front Upper Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength out rigger (5.3.6 (a) (i))

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

Offside Front Upper Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Front Lower Suspension arm corroded but not seriously weakened Both (5.3.3 (b) (i))

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement Front most bush (both sides) (5.3.4 (a) (i))

Front Windscreen wiper blade defective Both (3.4 (b) (i))

Headlamp lens slightly defective Both (4.1.1 (b) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Front Tyre(s) of different sizes are fitted on the same axle. (5.2.3 (b))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Rear Tyre(s) of different sizes are fitted on the same axle. (5.2.3 (b))

Rear fog lamp obviously incorrectly positioned (4.5.4 (a))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Rear Registration plate insecure (0.1 (a))

Emissions not tested Aborted due to overheating. (8.2.1.2 (d))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Tyre has a tear, caused by separation or partial failure of its structure Tyre also worn on inner edge. (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Valve stem seriously damaged (5.2.3 (j)) DANGEROUS

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Valve stem seriously damaged (5.2.3 (j)) DANGEROUS

Offside Front Tyre has a tear, caused by separation or partial failure of its structure Tyre also worn on inner edge. (5.2.3 (d) (ii)) DANGEROUS

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Front Lower Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Tyre slightly damaged/cracking or perishing Perishing (5.2.3 (d) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge 2.72mm (5.2.3 (e))

Offside Front Tyre slightly damaged/cracking or perishing Perishing (5.2.3 (d) (ii))

Offside Front Upper Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge 2.82mm (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Emissions not tested (8.2.1.2 (d))

Offside Front Track rod end ball joint dust cover insecure so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Central Rear Stop lamp has light sources not illuminating, but not more than 50% (1.2.1b)

Nearside Front Front suspension ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Rear Rear position lamp(s) not working (1.1.A.3b)

Central Rear Stop lamp has light sources not illuminating, but not more than 50% (1.2.1b)

Nearside Front Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Offside Front Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Stop lamp not working (1.2.1b)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)