2000 Iveco Daily

Bonnet retaining device excessively deteriorated (8.4.2)

Brake master cylinder/servo mounting prescribed area is excessively corroded (3.6.C.3)

Central Rear Lower Seat belt anchorage prescribed area is excessively corroded Crossmember (5.2.6)

Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Suspension component mounting prescribed area is inadequately repaired (2.4.A.3)

Nearside Headlamp aim too low (1.8)

Nearside Rear Electrical wiring deteriorated and bare wires exposed (1.9.2c)

Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Lower Steering component mounting prescribed area is excessively corroded (2.2.C.1h)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Rear fog lamp missing (1.3.2a)

Rear fog lamp not working (1.3.2b)

Rear registration plate missing (6.3.1a)

Steering column universal joint has excessive play (2.1.5) DANGEROUS

Front Vehicle structure has excessive corrosion which adversely affects braking or steering crossmember (6.1.A.1)

Nearside Brake pipe inadequately clipped front to rear (3.6.B.1)

Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings battery tray (6.1.B.2)

Nearside Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings inner wing at bulk head (6.1.B.2)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings step panel (6.1.B.2)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings step panel (6.1.B.2)

Offside Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Parking brake: efficiency below requirements (3.7.B.7)

Power steering ram(s) leaking from a failed component steering rack leaking (2.3.3b)

Rear position lamp(s) obviously incorrectly positioned both rear (1.1.A.3a)

Registration plate lamp not fitted (1.1.C.1b)

Steering system has excessive free play detected at the steering wheel (steering rack fitted) (2.2.A.1b)

Nearside Front Vehicle structure has slight corrosion step panel (6.1.B.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Various front body panels corroded.

Brake load sensing valve defective and function impaired (3.6.E.3)

Direction indicator not working (1.4.A.2c)

Hazard warning lamps inoperative (1.4.B.1b)

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim too low (1.8)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Power steering component(s) leaking (2.3.3b)

Stop lamp adversely affected by the operation of another lamp (1.2.1f)

Offside Inner Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Outer Rear Tyre worn close to the legal limit (4.1.E.1)

Oil leak

x member above prop mounting area corroded

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Inner Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Inner Rear Tyre worn close to the legal limit (4.1.E.1)

Oil leak

Battery insecure (1.9.1)

Brake load sensing valve inoperative (3.6.E.3)

Fuel tank insecure (7.2.1)

Nearside Headlamp aim too low (1.8)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Rear Body has a projection caused by damage (6.1.C.1)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Registration plate lamp insecure (1.1.C.1c)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Inner Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Inner Rear Tyre worn close to the legal limit (4.1.E.1)

Oil leak

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Body has slight corrosion (6.1.B.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

wiper controls by passed

Bonnet retaining device ineffective (8.4.2)

Nearside Brake cable insecure (3.5.1d)

Nearside Brake pipe excessively corroded (3.6.B.2c)

Nearside Headlamp aim too high (1.8)

Offside Front Body has a sharp edge caused by damage (6.1.C.1)

Offside Headlamp not working on dipped beam (1.7.5a)

Rear fog lamp missing (1.3.2a)

Registration plate lamp not fitted (1.1.C.1b)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Body has slight corrosion (6.1.B.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

wiper control by passed

Brake pipe excessively corroded (3.6.B.2c)

Nearside Stop lamp not working (1.2.1b)

Rear fog lamp not working (1.3.2b)

Oil leak

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Rear Brake load sensing valve has been disconnected and was fitted as standard (3.6.E.2)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Front Brake pipe slightly damaged (2.2.D.2b)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)