2000 Honda Accord

Brake pipe excessively corroded Front to rear in side plastic cover (1.1.11 (c))

Emissions not tested (8.2.1.2 (d))

Exhaust has a major leak of exhaust gases Middle and back boxes (6.1.2 (a))

Nearside Front Brake pipe excessively corroded In engine bay (1.1.11 (c))

Both headlamp beam pattern very poor and lens faded

Factory fitted covers

Front to rear fuel pipes very corroded in side plastic covers with brake pipes

Fuel filler neck rubber hose clip broken

Offside Front Tyre worn close to legal limit/worn on edge Inner edge wearing low and nail in inner edge of tread (5.2.3 (e))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

exhaust cat joints very corroded

rear sub-frame rusty

Brake pipe corroded, covered in grease or other material front to rear cannot see how bad covered with plastic trim but look bad? (1.1.11 (c))

Exhaust has a minor leak of exhaust gases back box by joint small hole and very corroded and middle pipe joint to back box corroded too (6.1.2 (a))

Nearside headlamp washer jet missing and no water coming out?

Offside Front Tyre worn close to legal limit/worn on edge inner edge wearing a bit low ? (5.2.3 (e))

Position lamp light intensity obviously reduced fronts a bit dim (4.2.3 (a) (i))

both headlamp beam pattern poor just see and lens faded and on lowest setting

exhaust front pipe flexy outer cover split a bit

Brake pipe corroded, covered in grease or other material both front to rear (1.1.11 (c))

Nearside Headlamp has a product on the light source but not seriously reducing light output (4.1.4 (b))

front and rear sub-frame rusty

head light wash not working

All direction indicators incorrect colour (4.4.3 (a))

Offside Front Anti-roll bar linkage ball joint likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Brake pipe corroded, covered in grease or other material both front to rear (1.1.11 (c))

Nearside Headlamp has a product on the light source but not seriously reducing light output (4.1.4 (b))

head light wash not working

All direction indicators slightly discoloured (4.4.3 (a))

front to rear brake pipes very corroded cannot assess covered in plastic trim

headlamp washers not working and nearside jet missing

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Anti-roll bar linkage insecure and impairing directional stability (5.3.3 (a) (ii)) DANGEROUS

All direction indicators slightly discoloured (4.4.3 (a))

front to rear brake pipes very corroded cannot assess covered in plastic trim

headlamp washers not working and nearside jet missing

Exhaust has a major leak of exhaust gases centre (7.1.2)

Nearside Headlamp aim too low (1.8)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside front brake excessively fluctuating (3.7.B.3)

Offside Headlamp aim too low (1.8)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Exhaust has a major leak of exhaust gases exhaust box (7.1.2)

Rear registration plate faded (6.3.1d)

Offside Rear Tyre has ply or cords exposed (4.1.D.1b) DANGEROUS

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Child seat fitted not allowing full inspection of adult belt

Front registration plate deteriorated (6.3.1d)

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim too low (1.8)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

offside front tyre has a cut/split.

Child seat fitted not allowing full inspection of adult belt

Exhaust has a minor leak of exhaust gases (7.1.2)