2000 Honda Logo

Exhaust has a minor leak of exhaust gases Centre joint. (6.1.2 (a))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Exhaust has a minor leak of exhaust gases Centre joint. (6.1.2 (a))

Offside Front Outer cv boot bamp

centre exhaust leeking

Emissions unable to be completed due to car overheating also exhaust leaking (8.2.1.2 (d))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting at suspension arm (6.2.2 (d) (i))

Offside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting at rear suspension arm (6.2.2 (d) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Outer cv boot bamp

centre exhaust leeking

vehicle underside corroded

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

vehicle underside corroded

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill holed (7.1.1 (a) (i))

exhaust centre section blowing

Nearside Front Headlamp light intensity severely reduced (4.1.4 (a))

Offside Front Headlamp light intensity severely reduced (4.1.4 (a))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Seat belt buckle not functioning as intended also twisted (7.1.2 (d))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Central Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Brake pipe excessively corroded to flex (1.1.11 (c))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Offside Front Brake pipe excessively corroded to flex (1.1.11 (c))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Anti-roll bar ball joint excessively worn (5.3.4 (a) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Front Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Front Brake pad(s) wearing thin (3.5.1g)

Brake performance not tested (3.7.A.1)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Brake pipe leaking (3.6.A.1)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Front Brake pad(s) wearing thin (3.5.1g)

Both front to rear brake pipes (at rear) are showing signs of heavy corrosion.

Both rear brake pipes (at rear drums) are showing signs of heavy corrosion.

Rear wiper blade torn.

All visible metal brake pipes that are exposed are showing signs of corrosion.

Both brake pipes (into rear drums) showing signs of corrosion.

Both front brake discs and pads are showing signs of wear.

Both front to rear brake pipes (at rear flexis) showing signs of corrosion.

Nearside Rear Stop lamp not working (1.2.1b)

Both brake pipes (into rear drums) showing signs of corrosion.

Both front brake discs and pads are showing signs of wear.

Both front to rear brake pipes (at rear flexis) showing signs of corrosion.

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear wiper torn.

Rear wiper torn.

O/S front tyre is beginning to feather on inside edge.

Brake pipe slightly corroded (3.6.B.2c)