2000 Ford Puma

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Suspension arm pin or bush worn but not resulting in excessive movement offside and nearside (5.3.4 (a) (i))

Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Tyre worn close to legal limit/worn on edge offside and nearside (5.2.3 (e))

Nearside Front Road wheel slightly distorted (5.2.2 (c) (i))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm bushes (5.3.4 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Central Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Tyre slightly damaged/cracking or perishing offside and nearside (5.2.3 (d) (ii))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Rear Axle has slight vertical movement between stub axle and axle beam (5.1.2 (c) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive offside and nearside (5.3.6 (a) (i))

Brake pipe corroded, covered in grease or other material front and rear (1.1.11 (c))

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive offside and nearside (5.3.6 (a) (i))

Brake pipe slightly corroded front and rear (3.6.B.2c)

Nearside Rear wheel bearing has slight play (2.6.2)

Offside Front Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Offside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Rear Suspension component mounting prescribed area is corroded but not considered excessive offside and nearside (2.4.A.3)

Front Anti-roll bar has slight play in a pin/bush offside and nearside (2.4.G.2)

Front Suspension arm has slight play in a pin/bush offside and nearside (2.4.G.2)

Rear Subframe mounting prescribed area is corroded but not considered excessive offside and nearside (2.4.A.3)

Rear wheel bearing has slight play offside and nearside (2.6.2)

all brake pipes corroded

offside and nearside under sills and chassis rails corroded

oil leak

Front Anti-roll bar has slight play in a pin/bush offside and nearside (2.4.G.2)

Front Suspension arm has slight play in a pin/bush offside and nearside (2.4.G.2)

Nearside Front Headlamp aim too high (1.8)

Nearside Front Headlamp not working on main beam (1.7.5a)

Offside Front Headlamp aim too high (1.8)

Rear Subframe mounting prescribed area is corroded but not considered excessive offside and nearside (2.4.A.3)

Rear wheel bearing has slight play offside and nearside (2.6.2)

all brake pipes corroded

offside and nearside under sills and chassis rails corroded

oil leak

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

N/S/F wheel buckled

Nearside Rear Trailing arm has slight play in a pin/bush (2.4.G.2)

Oil leak

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Macpherson strut has excessive movement at the upper attachment (2.5.A.1c)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Trailing arm has excessive play in a pin/bush (2.4.G.2)

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

N/S/F wheel buckled

Nail in nearside rear tyre

Nearside Rear Trailing arm has slight play in a pin/bush (2.4.G.2)

Oil leak

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

rear tyres perished

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Req's tracking

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Parking brake lever has no reserve travel (3.1.6b)

Rear Exhaust has part of the system excessively deteriorated (7.1.1a)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

nearside front tyre bald on inner edge

offside front tyre worn on inner edge

Exhaust has part of the system slightly deteriorated (7.1.1a)

Rear Macpherson strut has excessive movement at the upper attachment (2.5.A.1c)

Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Headlamp aim beam image too far to the right (1.6.B4)

Nearside Headlamp aim too high when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Nearside Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Headlamp aim too high when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Offside Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)