2000 Toyota Yaris

Brake performance not tested due to suspension damage (1.2.1 (g))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Front Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Suspension arm attachment bracket/mounting damaged and seriously weakened arm bent at balljoint (5.3.3 (b) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheelarch holed at bottom (5.3.6 (a) (i))

Offside Front Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Coil spring with an unsafe modification fouling body component (5.3.1 (d) (i))

Nearside Front Suspension component ball joint likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Exhaust has a minor leak of exhaust gases centre to rear (6.1.2 (a))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Direction indicator slightly discoloured (4.4.3 (a))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Rear Coil spring corroded Both side (5.3.1 (b) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Suspension arm corroded but not seriously weakened Both side (5.3.3 (b) (i))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Coil spring corroded Both side (5.3.1 (b) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Suspension arm corroded but not seriously weakened Both side (5.3.3 (b) (i))

Nearside Front Windscreen washer not working (3.5 (a))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Rear Shock absorber has a slightly reduced damping effect (2.7.5)

Front Tie bar/rod has excessive play in a pin/bush (2.4.G.2)

Rear Brake lining(s) less than 1.5 mm thick (3.5.1g)