2000 Peugeot Boxer

Central Front Lower Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength bulkhead and jacking point (5.3.6 (a) (i))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

slight chip in windscreen

Nearside Rear Upper marker light

slight play in front wheel bearings

Rear fog lamp not working (1.3.2b)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Nearside Rear Upper marker light

Offside Front Headlamp aim too low (1.8)

slight play in front wheel bearings

Offside Rear fog lamp not working (1.3.2b)

Nearside Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Rear Brake pipe excessively corroded (3.6.B.2c)

Rear Upper Stop lamp has less than 50% of the light sources illuminating (1.2.1b)

Nearside Front Front wheel bearing has slight play (2.5.A.3c)

Offside Front Front wheel bearing has slight play (2.5.A.3c)

exhaust corroded

front brakes 21% out of balance

Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front coil spring corroded (2.4.C.1b)

radiator bottom pannel corroded and weak

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Play in steering rack inner joint(s)

airbag warning lamp on

Horn not working (1.6.2a)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Rear fog lamp not working (1.3.2b)

Rear fog lamp switch missing (1.3.1a)

Windscreen washer provides insufficient washer liquid (8.2.3)