2000 Yamaha XT600

Drive chain slightly loose (6.1.7 (c) (i))

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Front Brake pad(s) close to minimum limit (1.1.13 (a))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Brake excessively binding (1.2.1 (f))

Drive chain slightly loose (6.1.7 (c) (i))

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Front Brake pad(s) close to minimum limit (1.1.13 (a))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Registration plate deteriorated but not likely to be misread (0.1 (b))

Brake pedal has slight side movement indicating a worn pedal bearing or pivot Rear brake control pedal pivot point for pedal worn & pivot point to cylinder worn, very close to gearbox casing but not effecting operation at time of test. (1.1.1 (b))

Front brake, brake fluid level close to minimum level.

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Wheel bearing has slight play (5.1.3 (a) (i))

Rear tyre in poor condition and has deep cuts but no cords or canvas exposed at time of test.

Wheel spoke slightly loose Rear wheel has multiple slightly loose spokes. (5.2.2 (d))

Rear Brake pedal has slight side movement indicating a worn pedal bearing or pivot (1.1.1 (b))

Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear reflector missing (4.8.2 (a) (ii))

Front Wheel bearing has excessive play (5.1.3 (a) (i))

Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Rear Brake pedal has slight side movement indicating a worn pedal bearing or pivot (1.1.1 (b))

Registration plate deteriorated but not likely to be misread (0.1 (b))

Brake pivot worn, but not excessively Rear brake lever pivot point & lower master cylinder pin pivot point worn. (1.1.15 (b))

Drive chain sprocket worn, but not excessively Front & Rear sprockets. (6.1.7 (c) (i))

Drive chain worn but not considered excessive (6.1.7 (c) (i))

Front Wheel bearing has slight play (5.1.3 (a) (i))

Front brake fluid close to 'low' level line.

Fuel cap has no rubber sealing ring but appears to be original design & does appear to go fully tight and maintain a seal.

No independent rear reflector fitted but rear lamp unit appears to be reflective.

Offside Front Wheel fixing missing (multiple fixings) Lower mounting point for wheel spindle has 1 snapped/missing stud & nut. (5.2.1 (a) (i))

Brake pivot worn, but not excessively Rear brake lever pivot point & lower master cylinder pin pivot point worn. (1.1.15 (b))

Drive chain sprocket worn, but not excessively Front & Rear sprockets. (6.1.7 (c) (i))

Drive chain worn but not considered excessive (6.1.7 (c) (i))

Front Wheel bearing has slight play (5.1.3 (a) (i))

Front brake fluid close to 'low' level line.

Fuel cap has no rubber sealing ring but appears to be original design & does appear to go fully tight and maintain a seal.

No independent rear reflector fitted but rear lamp unit appears to be reflective.

Lower Rear suspension bearing has slight free play (2.4.A2a(i))

Front Brake hose is likely to be fouled or trapped by moving parts (3.2.B2c)

Stop lamp does not illuminate immediately a brake applies Front brake (1.3.1a)

Vehicle identification number not permanently displayed (6.3.5a)

Lower Rear suspension bearing has slight free play (2.4.A2a(i))

Drive chain slightly loose (6.2.1d)

Drive chain worn but not considered excessive (6.2.1e)

Front Roller brake test indicates a slightly grabbing brake (3.3.A1b)

Rear Drive chain sprocket slightly worn (6.2.1e)

Front Wheel has an excessively distorted bead rim. (4.2.2)

Headlamp aim too low (1.6)

Rear Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Rear suspension bush has excessive free play (2.4.A2a(i))

Rear wheel bearings have excessive free play (2.4.A.2c)

Registration plate characters incorrectly spaced (6.3.4a)

Registration plate with character(s) which are not the correct width (6.3.4a)

Front suspension has a slightly reduced damping effect (2.3.6c)