2000 Fiat Coupe

Integral body structure is fractured but structural rigidity is not significantly reduced ns and os floor (6.1.1 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Sub-frame corroded but not seriously weakened both (5.3.3 (b) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced Subframe (6.1.1 (c) (i))

Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security Ns and is floor (6.2.2 (d) (i))

Sill covers fitted

Steering rack has slight free play detected at steering wheel (2.3 (a) (i))

Emissions not tested (8.2.1.2 (d))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Inner Integral body structure is corroded but structural rigidity is not significantly reduced sill/seat belt anchorage/suspension mounting (6.1.1 (c) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Inner Integral body structure is corroded but structural rigidity is not significantly reduced sill/seat belt anchorage/suspension mounting (6.1.1 (c) (i))

Oil leak, but not excessive engine (8.4.1 (a) (i))

Supplementary restraint system warning lamp does not illuminate (7.1.6 (a))

sill covers and under trays fitted

Supplementary restraint system warning lamp does not illuminate (7.1.6 (a))

Front Lower Exhaust catalytic converter missing where one was fitted as standard (8.2.2.1 (a))

Nearside Front Brake pipe excessively corroded BOTH (1.1.11 (c))

Nearside Headlamp aim too high (4.1.2 (a))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Emissions not tested (7.3.A.1)

Exhaust catalytic converter missing where one was fitted as standard (7.1.3)

Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Side repeater not working (1.4.A.2c)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Inner Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Registration plate lamp not working (1.1.C.1d)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Nearside Front Brake hose slightly damaged (3.6.B.4d)

Nearside Rear Trailing arm has slight play in a pin bearing (2.4.G.2)

Nearside Front Steering rack gaiter split (2.2.D.2d)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

repair to exhaust system ok no leak, but poor repair.

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Rear Brake pad(s) wearing thin (3.5.1g)