2000 Jaguar Xj

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Suspension arm corroded but not seriously weakened NSF and OSF (5.3.3 (b) (i))

Suspension component mounting prescribed area is corroded but not considered excessive All prescribed and non prescribed areas of the underside are clearly corroded but heavily coated with rustproofing. (5.3.6 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits SEE ABOVE (CAT LEAK) (8.2.1.2 (c))

Front Exhaust has a major leak of exhaust gases NS CAT LEAKING (6.1.2 (a))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Parking brake inoperative on one side HANDBRAKE CABLE MOUNTING HEAVILY CORRODED AND BROKEN UP. (1.4.1 (a))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

BOTH EMISSIONS AND BRAKE RESULTS ADANDONED DUE TO ABOVE FAULTS

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Suspension arm corroded but not seriously weakened NSF and OSF (5.3.3 (b) (i))

Suspension component mounting prescribed area is corroded but not considered excessive All prescribed and non prescribed areas of the underside are clearly corroded but heavily coated with rustproofing. (5.3.6 (a) (i))

Nearside Front Suspension component mounting prescribed area is excessively corroded floor to sill (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded chassie (2.4.A.3)

Rear Sub-frame corroded and seriously weakened (2.4.G.1)

Suspension component mounting prescribed area is excessively corroded o/s and n/s floors to sills (2.4.A.3)

Nearside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Rear wheel bearing has slight play (2.6.2)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Lower Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Parking brake: efficiency below requirements (3.7.B.7)

Track rod end ball joint has slight play (2.2.B.1f)

Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)