2000 Suzuki Carry

Emissions unable to be completed (8.2.1.2 (d))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security jacking point (6.2.2 (d) (i))

Front Play in steering rack inner joint(s) ()

Underbody corrosion present

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Central Exhaust rubber missing

Front Play in steering rack inner joint(s) ()

Underbody corrosion present

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Suspension component mounting prescribed area is inadequately repaired outer sill - lower section of patch, not continuous weld (2.4.A.3)

Nearside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Nearside Rear tyre perished & cracking in the tread

Offside Front tyre worn on outer edge & perished

Parking brake lever has little reserve travel (3.1.6b)

Play in steering rack inner joint(s) ()

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

centre exhaust rubber missing

underside has slight corrosion

nearside rear tyre perished

slight play in steering arms

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Vehicle structure has slight corrosion (6.1.A.1)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Vehicle structure has slight corrosion (6.1.A.1)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

nearside rear tyre perished

slight play in steering arms

Offside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

corrosion inside side step on near side

Emissions not tested (7.0)

Offside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

catalyctic convertor inerds broken up

corrosion inside side step on near side

rear silencer baffles broken up

Engine covers fitted obscuring some components in the engine bay

Play in steering rack inner joint(s)

Under-trays fitted obscuring some underside components

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Engine covers fitted obscuring some components in the engine bay

Play in steering rack inner joint(s)

Under-trays fitted obscuring some underside components

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

both rear tyres perishing and getting low on tread

handbrake travel high