2000 BMW F650

Nearside Front Brake pad(s) close to minimum limit (1.1.13 (a))

Central Rear Shock absorber has negligible damping effect Adjuster wound too far off and not touching spring - adjusted (5.3.2 (b))

Nearside Front Brake pad(s) close to minimum limit (1.1.13 (a))

Central Rear Lower Shock absorber has a slightly worn bush (5.3.2 (c))

Central Rear Upper Shock absorber has a slightly worn bush (5.3.2 (c))

Rear Brake hose slightly deteriorated (1.1.12 (b) (ii))

Steering headbearing has slight free play (2.2.2 (f) (i))

Central Front Headlamp aim too high (4.1.2 (a))

Central Rear Lower Shock absorber has a slightly worn bush (5.3.2 (c))

Central Rear Upper Shock absorber has a slightly worn bush (5.3.2 (c))

Rear Brake hose slightly deteriorated (1.1.12 (b) (ii))

Steering headbearing has slight free play (2.2.2 (f) (i))

Rear Footrest insecure (6.2.12 (a))

Steering headbearing has excessive wear or free play (2.2.2 (f) (i))

Wheel alignment incorrect which adversely affects the steering (2.4 (a))

Rear Brake fluid reservoir fluid level below minimum level (1.1.10 (d) (i))

Front shock absorber seal failed and leaking oil (2.3.3)

Drive chain excessively tight tight spots (6.2.1d)

Front Brake fluid reservoir fluid level dangerously low (3.2.B1d)

Handlebar deformed (2.1.1b)

Rear suspension fouling which affects the movement of the rear suspension (2.4.A.3a)

Roller brake test Neither brake control achieves an efficiency of 25% (3.3.A2b)

Front Tyre worn close to the legal limit (4.1.3(ii))

Rear Tyre worn close to the legal limit (4.1.3(ii))

Rear Brake pedal pivots slightly worn (3.1.3a)

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Nearside Front shock absorber seal failed and leaking oil (2.3.3)

Offside Front shock absorber seal failed and leaking oil (2.3.3)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Headlamp aim not tested (1.6)

Centre Riders seat insecure (6.2.1a)

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Front Headlamp aim too high (1.6)

Front Stop lamp remains on when the brake is released (1.3.1e)

Rear Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Rear Rear position lamp adversely affected by the operation of another lamp (1.1.3b)

Rear Stop lamp remains on when the brake is released (1.3.1e)