2000 Mercedes-benz Sprinter

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Front tyre wearing on inner edge

offside /nearside sills corroded to excess not structual

Brake load sensing valve linkage seized (3.6.E.3)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Body has a sharp edge caused by damage mirror housing (6.1.C.1)

Nearside Rear Body has a sharp edge caused by corrosion wheel arch (6.1.C.1)

Nearside Rear Suspension component mounting prescribed area is excessively corroded chassis (2.4.A.3)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Brake hose excessively deteriorated (3.6.B.4d)

Offside Rear Suspension spring mounting prescribed area is excessively corroded chassis (2.4.A.3)

Rear Exhaust has a major leak of exhaust gases tail pipe (7.1.2)

Registration plate lamp not working (1.1.C.1d)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Front tyre wearing on inner edge

offside /nearside sills corroded to excess not structual

Front registration plate deteriorated but not likely to be misread (6.3.1d)

N/S/R O/S/R wheel arch rust at in side rear

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

O/S/R/spring shows signs of moving

Offside Front Valve stem slightly damaged (4.1.D.1e)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Front Tyre has ply or cords exposed (4.1.D.1b)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Headlamp not working on main beam (1.7.5a)

Offside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Registration plate lamp not working (1.1.C.1d)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Rear fog lamp not working (1.3.2b)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

N/S/R O/S/R wheel arch rust at in side rear

O/S/R/spring shows signs of moving

Offside Front Valve stem slightly damaged (4.1.D.1e)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Front Lower Suspension arm has excessive play in a pin/bush (2.4.G.2)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Direction indicator incorrect colour (1.4.A.2f)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear fog lamp not working (1.3.2b)

Brake load sensing valve stiff (3.6.E.3)

Brake pipe slightly corroded (3.6.B.2c)

Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Rear Brake hose slightly deteriorated (3.6.B.4d)

nearside front tyre wall damaged

nearside rear tyre walls perished and cracking

offside rear tyre tread cut

Nearside Rear Leaf spring saddle is moving relative to the spring (2.4.B.7a)

Offside Front Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Rear fog lamp not working (1.3.2b)

Offside Rear position lamp(s) not working (1.1.A.3b)

Offside Stop lamp not working (1.2.1b)

Registration plate lamp not working (1.1.C.1d)

Brake load sensing valve stiff (3.6.E.3)

Brake pipe slightly corroded (3.6.B.2c)

Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Rear Brake hose slightly deteriorated (3.6.B.4d)

nearside front tyre wall damaged

nearside rear tyre walls perished and cracking

offside rear tyre tread cut

front bump stop suspension clearances could be better

Brake pipe slightly corroded (3.6.B.2c)

Nearside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Brake load sensing valve linkage seized (3.6.E.3)

Front Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Nearside Rear Leaf spring saddle is moving relative to the spring (2.4.B.7a)

Offside Rear Leaf spring to axle securing bolt insecure (2.4.B.7b)

Rear Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Registration plate lamp not working (1.1.C.1d)

Brake pipe slightly corroded (3.6.B.2c)

Nearside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

front bump stop suspension clearances could be better

Brake hose slightly deteriorated (3.6.B.4d)

Brake load sensing valve linkage stiff (3.6.E.3)

Nearside Front Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Nearside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Front Brake pad(s) wearing thin (3.5.1g)

front discs worn

front suspension clearances could be better close to the limit

n/s/r tyre tread cut filled with stones

o/s/f tyre tread cut

Nearside Rear Leaf spring to axle securing nut insecure (2.4.B.7b)

Nearside Side repeater not working (1.4.A.2c)

Offside Rear Leaf spring to axle securing bolt insecure (2.4.B.7b)

Offside Stop lamp not working (1.2.1b)

Registration plate lamp not working (1.1.C.1d)

rear brake application uneven (3.7.B.2)

Brake hose slightly deteriorated (3.6.B.4d)

Brake load sensing valve linkage stiff (3.6.E.3)

Nearside Front Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Nearside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Front Brake pad(s) wearing thin (3.5.1g)

front discs worn

front suspension clearances could be better close to the limit

n/s/r tyre tread cut filled with stones

o/s/f tyre tread cut

Brake hose slightly deteriorated (3.6.B.4d)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

area under n/s/r wheel arch corroded

both front bump stop clearances could be better

front disc brakes slightly worn

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Side repeater not working (1.4.A.2c)

Offside Rear fog lamp not working (1.3.2b)

Offside Stop lamp not working (1.2.1b)

Registration plate lamp not working (1.1.C.1d)

Brake hose slightly deteriorated (3.6.B.4d)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

area under n/s/r wheel arch corroded

both front bump stop clearances could be better

front disc brakes slightly worn

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim too low (1.8)

Offside Rear fog lamp not working (1.3.2b)

Rear fog lamp tell tale not working (1.3.1b)

Nearside Front Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Offside Front Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

pre heat light on dash

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

brinding smell from nearside rear brake but is not brinding at present