2000 Yamaha R6

Front Steering damper slightly loose (2.1.4 (d) (i))

Rear Tyre worn close to the legal limit (5.2.3 (e))

Front Steering damper slightly loose (2.1.4 (d) (i))

Front Stop lamp not working (4.3.1 (a) (ii))

Rear Tyre worn close to the legal limit (5.2.3 (e))

Drive chain slightly tight (6.1.7 (k) (i))

Front Brake indicates slight fluctuation of brake effort (1.2.1 (e))

Front Stop lamp does not illuminate by the operation of both brake controls (4.3.2 (a) (iii))

Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Front Wheel has an excessively distorted bead rim. (4.2.2)

Front Wheel has an excessively eccentric bead rim. (4.2.2)

Headlamp aim too low (1.6)

Indicator switch insecure nearside switch gear insecure (1.5.4)

Position lamp switch insecure offside switchgear insecure. (1.1.4b)

Chain guard missing

Exhaust noisy (7.1.2)

Rear Brake disc(s) slightly worn (3.2.A1l)

Wheel alignment slightly misaligned. (2.5.1)

both front discs secured with alloy bolts.

both tyre pressures very low. inflated for test.

front and rear brakes binding slightly, but not enough for failure.

horn wires get trapped between lock stop and yoke on right hand lock.

number plate not of standard size but still legible from 15 metres.

rear sprocket secured with alloy nuts.

Front Roller brake test indicates a binding brake (3.3.A1a)

Rear Brake cylinder slightly corroded (3.2.B1b)

Rear Brake pad(s) close to minimum limit (3.2.A1f(i))

rear stop light is not very bright but not worthy of a fail

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear wheel bearings have slight free play (2.4.A.2c)

rear sprocket bearing has slight play

rear stop light is not very bright but not worthy of a fail

Drive chain worn but not considered excessive (6.2.1e)

Drive chain worn but not considered excessive (6.2.1e)

Rear reflector on motorcycle missing (1.4.1)

Drive chain slightly tight (6.2.1d)

Rear Registration plate incorrect (6.3.1a)

Drive chain slightly tight (6.2.1d)

Rear Registration plate margin less than the minimum requirement (6.3.4g)

Rear Registration plate with character(s) which are not the correct height (6.3.4a)

Rear Registration plate with character(s) which are not the correct width (6.3.4a)

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Rear Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Rear Registration plate incorrect (6.3.1a)