2000 Peugeot 106

Electronic stability control warning lamp indicates a fault (7.12 (e))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Exhaust catalytic converter missing where one was fitted as standard (8.2.2.1 (a))

Front Exhaust has a major leak of exhaust gases (6.1.2 (a))

Offside Front Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Chassis and surrounding panels inside wheel arch and around aperture for steering track rod. marked with yellow wax (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor to sill end/wheel arch closure panels above rear axle mounting points and fuel filler neck. marked with yellow wax (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Exhaust noisy (8.1.1 (a))

Nearside Brake pipe inadequately clipped or supported front to rear at rear fouling adjacent pipe and hand brake cable. (1.1.11 (d) (i))

Nearside Front Electrical wiring insulation slightly damaged or deteriorated to head light (4.11 (c) (i))

Nearside Front Side repeater slightly discoloured (4.4.3 (a))

Nearside Rear Brake pipe corroded, covered in grease or other material from load sense valve to nearside rear flexi (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material from load sense valve to offside rear flexi is corroded in clips. (1.1.11 (c))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive floor to sill end/wheel arch closure panels unable to access to test properly as brake components and exhaust restrict access. (5.3.6 (a) (i))

Offside Front Side repeater slightly discoloured (4.4.3 (a))

Offside Front showing signs of corrosion.

Oil leak, but not excessive (8.4.1 (a) (i))

Supplementary restraint system warning lamp does not illuminate (7.1.6 (a))

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Offside Front Vehicle structure has slight corrosion inner sill (6.1.A.1)

Nearside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Offside Steering rack gaiter deteriorated (2.2.D.2d)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

front tyres both on 3mm

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust has a major leak of exhaust gases (7.1.2)

Front Side repeater incorrect colour (1.4.A.2f)

Rear registration plate character(s) likely to be misread (6.3.4b)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

front tyres both on 3mm

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Front Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Upper Tyre worn close to the legal limit (4.1.E.1)

Offside Front Lower Tyre worn close to the legal limit (4.1.E.1)