2000 Mazda MX-5

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Nearside Rear Brake cable insecure not connected to calliper (1.1.15 (c))

Nearside Rear Inner Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis leg (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill/floor (5.3.6 (a) (i))

Exhaust mounting defective 2 x rear (6.1.2 (a))

Nearside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Suspension arm corroded but not seriously weakened all (5.3.3 (b) (i))

Suspension arm pin or bush worn but not resulting in excessive movement all rubber bushes perished (5.3.4 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Central Vehicle structure is corroded but structural rigidity is not significantly reduced both chassis legs (6.1.1 (c) (i))

Central Vehicle structure is deformed but structural rigidity is not significantly reduced both chassis legs (6.1.1 (a) (i))

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Exhaust mounting defective back box rubber hangers x2 (6.1.2 (a))

sill covers fitted

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Nearside Inner Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Offside Inner Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Offside Outer Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Offside Rear Upper Anti-roll bar linkage insecurely attached (5.3.3 (a) (i))

Rear fog lamp tell-tale missing (4.9.1 (a) (ii))

Central Vehicle structure is corroded but structural rigidity is not significantly reduced both chassis legs (6.1.1 (c) (i))

Central Vehicle structure is deformed but structural rigidity is not significantly reduced both chassis legs (6.1.1 (a) (i))

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Exhaust mounting defective back box rubber hangers x2 (6.1.2 (a))

sill covers fitted

Nearside Rear Inner Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill (6.1.B.2)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Offside Rear Brake pipe repaired, but not inappropriately (3.6.A.3)

Under-trays fitted obscuring some underside components

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear coil spring broken (2.4.C.1a)

Rear fog lamp tell tale not working (1.3.1b)

n/s headlight. light output reduced

Nearside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

rear brake pads getting low and rear brake discs corroded

Brakes imbalanced across an axle (3.7.B.5b)

Front front brake application uneven (3.7.B.2)

Front front brakes release unevenly (3.7.B.4)

Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

all brake discs starting to corrode

front and rear brake discs starting to corrode